Sanyo KHS1852 Air Conditioner User Manual


 
Using the Remote Control Unit
How to Install Batteries
NOTE
The batteries last about six months, depending on how much you use
the remote control unit. Replace the batteries when the remote control
unit's display fails to light, or when the remote control cannot be used
to change the air conditioner’s settings.
Use two fresh leak-proof type-AAA alkaline batteries.
In replacing batteries, follow the instructions as mentioned in the
sub-section “How to Install Batteries”.
If you do not use the remote control unit more than 1 month, take out
the batteries.
How to Use the Remote
Control Unit
When using the remote control unit, always point the unit’s transmitter
head directly at the air conditioner's receiver.
Remote Control Unit
Installation Position
The remote control unit may be operated either from a non-fixed position
or from a wall-mounted position. To ensure that the air conditioner operates
correctly, DO NOT install the remote control unit in the following places:
DO NOT
In direct sunlight
Behind a curtain or other places where it is covered
More than 26 feet (8 m) away from the air conditioner
In the path of the air conditioner’s airstream
Where it may become extremely hot or cold
Where it may be subject to electrical or magnetic noise
Where there is an obstacle between the remote control unit and air
conditioner (since a check signal is sent from the remote control unit
every 5 minutes)
ACL button
1. Slide the cover in the direction indicated by
the arrow and remove it.
2. Install two AAA alkaline batteries. Make sure
the batteries point in the direction marked in
the battery compartment.
3. Use a thin object such as the tip of a pen to
press the ACL button.
Cover
Air conditioner
(Indoor unit)
Remote control
unit
Receiver
(Transmitter head)
10 OI-202-12EG
oi202000