Filter
Top Products
These units are designed to meet or exceed ANSI
(American National Standards Institute) require-
ments and have been tested according to D.O.E.
test procedures and meet or exceed the energy
efficiency requirements of NAECA, ASHRAE
standard 90, ICC Code and all state energy
efficiency performance criteria for energy
consuming appliances.
Before purchasing this appliance, read important
energy cost and efficiency information available
from your supplier.
Rheem Water Heaters • 101 Bell Road, Montgomery, Alabama 36117 • www.rheem.com
PRINTED IN U.S.A 04/05 WP FORM NO. 101W-10 Rev. 3
In keeping with its policy of continuous progress and product improvement, Rheem reserves the right to make changes without notice.
C
A
B
RELIEF
VALVE
RELIEF
VALVE
COLD
OUTLET
HOT
OUTLET
JUNCTION
BOX
ANODE
COLD
INLET
DOUBLE
ELEMENT
AVAILABLE
ON 30, 40
& 50 GAL.
ONLY
3"
WATER CONNECTIONS
ALL 3/4" N.P.T.
Warrior Rheemglas
®
Electric Water Heater for Manufactured Housing
Available in 20, 30, 40 and 50 Gallon Models
5-Year Limited Tank Warranty*
1-Year Limited Parts Warranty*
•
Lifeguard
™
stainless steel element**
•
Isolated tank design reduces heat loss
•
High efficiency heating elements
•
Exclusive Rheemglas
®
tank lining resists
corrosion and prolongs tank life
•
Anode rod equalizes aggressive water
action
•
Automatic temperature control thermostat
•
Over-temperature protector automatically
cuts off power in excess temperature
situations
•
Electrical junction box (for 1/2" and 3/4"
conduit) placed above heating elements
for easy installation
•
Meets H.U.D. Safety and Construction
Standards, ASHRAE 90A-80 and
National Appliance Energy Conservation
Act (NAECA) requirements
Design evaluated in accordance with Part 3280.707(d)(1)
or (2) of HUD Mobile Home Construction and Safety
Standards for Energy Efficiency.
* See Residential Warranty Information Brochure for complete
warranty information.
** Double element models upper element only.
Energy Factor and Average Annual
Operating Costs based on D.O.E.(Department
of Energy) test procedures.D.O.E.national
average fuel rate electricity 8.6¢/KWH.
• If heating elements of different wattages than those
shown are demanded by zone requirements,they
must be specifically requested.
• Heaters furnished with standard 240 volt AC, single
phase non-simultaneous wiring, and 3500 watt or 4500
watt heating elements.71-20 furnished with standard
120 volt AC, single phase, 2000 watt heating element.
• Special Wiring Options – A limited number of special
wiring options are available.Consult factory for price
and availability.
• For single element, substitute “-1” suffix for “-2”.
SIDE CONNECT
®
DESCRIPTION FEATURES ROUGHING IN DIMENSIONS (SHOWN IN INCHES) ENERGY INFORMATION
FIRST HOUR RECOVERY IN G.P.H. TANK HEIGHT TO APPROX. AVERAGE
GAL.
RATING G.P.H. @ 90° RISE
HEIGHT WATER CONN. DIAMETER SHIP WT. ENERGY ANNUAL
CAP. MODEL NUMBER
3500 WATTS 4500 WATTS 3500 WATTS 4500 WATTS
A B C (LBS.) FACTOR OPER. COST
T
A
L
L
T
Y
P
E
SIDE CONNECT
20 72V20-1 – – – – 31-1/2 25-1/2 17-3/4 62 N/A N/A
30 72V30-2 41 46 16 21 45-1/2 39-3/4 17-3/4 70 0.93 $406
40 72V40-2 47 51 16 21 46-3/4 40-1/4 19-3/4 94 0.92 $411
50 72V52-2 51 56 16 21 57 50-3/4 19-3/4 108 0.91 $415
Recovery = wattage/2.42 x temp. rise °F.
Example:
4500W
= 21 GPH
2.42 x 90°