Filter
Top Products
• Holding the top of the mask tubing, squeeze and pull the pillows
away from the mask frame.
• Remove the headgear from the stabilisers by holding the fabric
end of each strap and pulling out to reveal the buttonhole, then
slide over the node and off the end of each stabiliser. Your mask
is now disassembled.
P10
AirFit
Nasal Pillows System
Disassembly for AirFit P10
• With the grey side facing out, insert each end of the headgear strap over the stabilisers through the buttonholes. Secure in place by
wrapping each strap end-up, and around the nodes. Holding the split straps, pull the headgear from the stabilisers to make sure they
are tightly secured around the nodes. Ensure the headgear strap isn’t twisted.
Reassembly for AirFit P10
• Attach the pillows to the mask frame by inserting the shorter clip
into the top slot, and the longer clip into the lower slot on the mask
frame. Your mask is now reassembled.
ResMed Ltd
1 Elizabeth Macarthur Drive,
Bella Vista, NSW 2153 Australia .
DISTRIBUTED BY
ResMed (UK) Ltd, 96 Jubilee Avenue,
Milton Park, Abingdon, Oxfordshire, OX14 4RW UK.
AirFit is a trademark of ResMed Ltd. Specifications may change without notice. © 2013 ResMed Ltd.
1016830/1 2013-11
Note: For complete user instructions, refer to the AirFit P10 User Guide.
• Ensure the inner walls of the nasal pillows are not compressed or
collapsed. If they are, squeeze each nasal pillow so they return to
the correct shape.
www.resmed.com
1
1
2 3
2