Filter
Top Products
4
4. Connect the 8-Pin iPod docking cable into the rst port on the Media Gateway
(farthest away from dipswitches). Carefully run the 11 foot iPod cable behind the dash
to the location where the iPod will be mounted or stored (for example the glove box
or center console). This location will vary based on the vehicle, and the customer’s
prefrence. When running this cable through the dash be sure to secure it away from
moving parts or sharp metal edges that may damage the cable.
5. If connecting the HD Radio Tuner (HDRT sold separately), make the following
connections before connecting the PXAMG to the vehicle. Plug the 3 foot HD
Radio Cable (8-Pin mini-din to 8-Pin mini-din) into the second port (closest to the
dipswitches) on the Media Gateway. Connect the other end of this cable into the HD
Radio tuner. Connect the factory antenna cable into the antenna connection on the
HD Radio tuner (HDRT) using a Best Kits BAA36 antenna adaptor (or equivalent) if
needed to make this connection.
6. Plug in the male connectors on the PGHNI2 harness into the 20-pin and 12-
pin ports on the back of the radio. Next, connect the factory 20-pin and 12-pin
harnesses into the female connectors on the PGHNI2 harness. Be sure to make a
rm connection but do not force it. Plug the Black micro-t 24-pin connector on the
PGHNI2 harness into the PXAMG Media Gateway box.
7. To complete the installation secure the Media Gateway (PXAMG) and HD Radio
tuner (HDRT) into the cavity in the dash behind the radio. Be sure that the cables
and interface modules are not near moving parts or sharp metal edges as they may
damage the cables. To prevent rattling noises inside the dash use zip ties, tape or
other fasteners to mount the interfaces securely.
8. With all connections made, reconnect the vehicle’s battery, insert the key into the
ignition, and turn the vehicle on. Check for proper operation of the Media Gateway
and HD Radio tuner before reinstalling the factory dash panels.
9. Note: The rst time you access the Media Gateway, your radio may display “DEV
INIT” while the device is initializing. If this is displayed, please wait one minute then
cycle the ignition off and on. Then access SAT mode again to begin normal gateway
operation.
6. Pathnder & Armada
iPod Operation
Entering Mode Select Menu
Press the “AM/FM/SAT” button a few times until “SAT” is displayed on the screen.
Immediately turn the rotary tune knob to scroll through the available sources. Once
“IPOD” is displayed, press the “<<SEEK” button to select it.
Next Track
Turn the rotary tune knob clockwise to advance to the next track.
Previous Track
Turn the rotary tune knob counter clockwise to return to the previous track.