Filter
Top Products
IMPORTANT SAFEGUARDS AND WARNINGS
Prior to installation and use of this product, the following WARNINGS should be observed.
1. Installation and servicing should only be done by qualified service personnel and conform
to all local codes.
2. Installation shall be done in accordance with all local and national electrical and mechani-
cal codes utilizing only approved materials.
3. Use only installation methods and materials capable of supporting four times the maxi-
mum specified load.
4. Use stainless steel hardware to fasten the mount to outdoor surfaces.
5. To prevent damage from water leakage when installing a mount outdoors on a roof or
wall, apply sealant around the bolt holes between the mount and mounting surface.
The product and/or manual may bear the following marks:
Please thoroughly familiarize yourself with the information in this manual prior to installation
and operation.
C228M (3/99)
MM22
Enclosure Mount
3500 Pelco Way,
Clovis, CA 93612-5699
USA
In North America & Canada:
Tel (800) 289-9100
FAX (800) 289-9150
International Customers:
Tel (1-559) 292-1981
FAX (1-559) 348-1120
www.pelco.com
®
This symbol indicates that danger-
ous voltage constituting a risk of
electric shock is present within
this unit.
This symbol indicates that there
are important operating and main-
tenance instructions in the litera-
ture accompanying this unit.
CAUTION:
RISK OF ELECTRIC SHOCK.
DO NOT OPEN.
LISTED
U
L
®
DESCRIPTION
The MM22 Pedestal/Wall Mount has been engineered for use with light-to-medium weight cam-
eras and various Pelco enclosures having a 2-inch mounting hole pattern.
The MM22 can be installed on a ceiling or any horizontal surface and will support up to 40
pounds (18 kg).
The MM22 features a fully adjustable swivel head allowing 360°
horizontal movement.
INSTALLATION
The MM22 mount is supplied with two 1/4-20 x .625 hex head bolts for use in attaching the
enclosure/camera to the mount.
If installing outdoors, stainless steel hardware is recommended.
To install the mount:
1. Drill holes in the mounting surface using the mount as a template and attach mount se-
curely with the required fasteners.
If you install the mount outdoors, rain water could leak through the holes for the mounting
bolts and damage the wall. This could be a problem only if the mounting bolts go com-
pletely through the roof or wall.
To prevent water damage, seal the bolt holes with an appropriate sealant. Apply the seal-
ant around the bolt holes between the mount and the mounting surface.
2. Attach the enclosure or camera securely with the two 1/4-20 hex head screws provided.
3. Loosen the hex head bolts on the swivel head and adjust for pan rotation (360°) and tilt
angle (75° up or down). Tighten bolts and lock into place.
NOTE:
Fasteners to secure the
MM22 (4 required) to the mount-
ing surface
are not
supplied.
(Minimum 1/4-inch diameter rec-
ommended.)
CAUTION:
Make cer-
tain the mounting sur-
face is able to support
the full load of the mount, enclo-
sure, and camera.