Filter
Top Products
78
2. Input/output signal settings
2-1-3. Setting the delay amount
The input signals can be delayed.
The delay can be applied only to the SDI IN7 and SDI IN8
input signals.
On the Input sub menu, use [F2] to select the input to
be set using the Select item.
Refer to “2-1. Input signal settings”.
Use [F1] to display the FS sub menu.
Use [F4] to set the delay amount using the Delay item.
2-1-4. Freezing the input signals
The input signals can be frozen and used.
While signals are frozen, the tally signals of the corresponding
input will not be output.
Setting freeze
On the Input sub menu, use [F2] to select the input to
be set using the Select item.
Refer to “2-1. Input signal settings”.
Use [F1] to display the Freeze sub menu.
Use [F2] to select the freeze method using the Select
item.
Frame The images are frozen frame by frame.
Field The images are frozen fi eld by fi eld.
This is used to freeze moving images.
With interlace signals, however, diagonal
lines and moving parts appear jagged.
Frame or Field can also be selected while an image is
frozen.
Press the [F3] to freeze the input image or cancel the
freeze.
If the [F3] is pressed while the display is “Off”, the video
signal is frozen, and the display is set to “On”.
If the [F3] is pressed while the display is “On”, the video
signal freezing is canceled, and the display is set to
“Off”.
The “F” mark appears in front of the name of the
material when the signals set for output of multi view
displays are frozen.
When the unit is used with the frame synchronizer
function OFF, the output images may be disturbed when
freezing is executed, but the frozen images will not be
adversely affected.
If, when the switcher is used with the frame synchronizer
function at OFF, “On” is set as the freeze setting, the
frame synchronizer function will be automatically
switched to ON.
2-1-5. Setting the material names
Material names can be given to the input signals.
These names can be selected from the default settings or
user settings.
On the Input sub menu, use [F2] to select the input to
be set using the Select item.
Refer to “2-1. Input signal settings”.
Use [F1] to display the Name sub menu.
Use [F2] to select the type of material names using the
Type item.
Default
(default
settings)
Select the material names from the following:
SDI IN1 to SDI IN8, DVI IN, IN-A1, IN-A2,
IN-B1 and IN-B2.
User
(user
settings)
The material names are set using up to 7
characters.