Filter
Top Products
31
Basic
operations
1. Basic operations
1-4-6. PinP adjustments
Adjusting the PinP position and size
While the PinP menu is selected, adjust the X and Y
coordinates using the positioner in the positioner area, and
adjust the size using the rotary encoder [Z]. Alternatively, the
settings can be performed on the menus.
Press the p button to light its indicator, and display the
PinP1 menu (or PinP2 menu).
Use [F1] to display the Position sub menu.
Either operate the positioner and the rotary encoder [Z]
or use [F2], [F3] and [F4] to set the X and Y coordinates
and the size using the X-Pos, Y-Pos and Size items.
Select the dot by dot mode
When the system is set to the HD mode and an SD format
image is to be used for the PinP material, the images can be
combined in the dot by dot mode (actual-size images).
In this mode, the SD format image will not be up-converted so
image deterioration can be prevented.
When “100.00” has been selected as the Size item
setting on the Position sub menu, the size used for the
combination will be the same number of lines as the SD
format image.
Press the i button to light its indicator, and display the
Input menu.
Use [F2] to select the signals for inputting the PinP
material using the Select item.
Use [F1] to display the FS sub menu.
Use [F3] to select “Dot by Dot” using the Mode item, and
press the [F3] to enter the selection.
SD HD
SD
PinP material
PinP combined image