Filter
Top Products
1
W415-0360 / 11.05.02
INSTALLATION AND OPERATION INSTRUCTIONS FOR
HI-TECH LISTED SOLID FUEL BURNING STOVES AND INSERTS
FREE STANDING MODELS
EPA 1100, 1100L, 1100C, 1400, 1400L
&
1900
INSERT MODELS
EPI 1101, 1401
INSTALLER: THESE INSTRUCTIONS MUST BE CONVEYED TO AND REMAIN WITH THE HOMEOWNER.
CERTIFIED UNDER U.S. ENVIRONMENTAL PROTECTION AGENCY (E.P.A.) JULY 1990 AND THE OREGON DEPARTMENT OF ENVIRONMENTAL QUALITY (D.E.Q.) PARTICULATE
EMISSION STANDARDS BY E.E.M.C. THESE STOVES HAVE BEEN TESTED AND LISTED BY WARNOCK HERSEY LTD. TO STANDARDS: CSA B366.2 , ULCS627, ULC S628, UL 1482.
MODEL 1100 HAS BEEN TESTED AND LISTED FOR INSTALLATION IN MOBILE HOMES.
Fax: (705)722-6031 www.napoleonfireplaces.com Email: ask@napoleon.on.ca
Wolf Steel Ltd., 24 Napoleon Rd.,
Barrie, ON., Canada L4M 4Y8 (705)721-1212
WARNING:
If this unit is not properly installed, a house fire may result.
FOR YOUR SAFETY
Follow the installation directions. This unit can be very hot when burning. Combustible materials
such as firewood, wet clothing, etc. placed too close can catch fire. Children and pets must be
kept from touching the unit when it is hot. The chimney must be sound and free of cracks. Before
installing your unit, contact the local building or fire authority and follow their guidelines.
Operate only with door tightly closed. Burn wood directly on firebricks. Do not use a grate or
elevate the fire. At least 14 square inches (90 sq.cm.) of outside air must be admitted to the room
or directly to the unit through a 4 inch (10cm.) diameter pipe. This unit is designed to burn natural
wood only. Higher efficiencies and lower emissions generally result when burning air dried sea-
soned hardwoods, as compared to softwoods or to green or freshly cut hardwoods. Do not start a
fire with chemicals or fluids such as gasoline, engine oil, etc. Do not burn treated wood, coal,
charcoal, coloured paper, cardboard, solvents or garbage which tend to produce more pollution
than wood. Do not let the unit become hot enough for any part to glow red.
KEEP THE STOVE TOP TEMPERATURE BELOW 700°F (371°C). Attempts to achieve heat output rates
that exceed design specifications can result in steel distortion and damage.
R-2000