Monessen Hearth GLX28 Gas Heater User Manual


 
14D2099
5
CAUTION
Handle the gas log burner assembly by the grate only. Do
not pick the unit up by the burners.
Gloves are recommended when handling ceramic fiber logs
to prevent skin irritation from loose fibers. Logs are fragile
handle with care.
MAKE SURE YOU HAVE RECEIVED ALL PARTS:
Check your packing list to verify that all listed parts have been received. You should have the following:
•Unvented gas log grate/burner assembly.
Installation/operating instructions.
•Ceramic fiber logs.
•Two (2) anchoring screws.
Plastic bag containing crushed volcanic rock.
The millivolt controlled version of this heater is the only style designed to be operated with optional devices for ON/OFF
functions. The following options may be used with the millivolt controlled heater. These options are
not packaged with the
log set.
•Hand held Remote w/receiver.
•Wall Switch with 20' wire.
•Wall T-stat with 20' wire.
•Hand held Thermostat Remote w/receiver.
Carefully inspect the contents for shipping damage. If any parts are missing or damaged, immediately inform the dealer from
whom you purchased the appliance. Do not attempt to install any part of the appliance unless you have all parts
in good condition.
What you will need for installation:
You must have the following items available before proceeding with installation:
External regulator (for propane/L.P.G. only)
Piping which complies with local codes
Pipe sealant approved for use with propane/L.P.G. (Resistant to sulfur compounds)
•Manual shutoff valve
Sediment trap
•Tee joint
Pipe wrench or appropriate size crescent wrench set
•Screwdriver
•Drill, with 5/32 bit
GETTING STARTED