Filter
Top Products
9
65D1009
EYF Series Unvented Gas Log Set
To
install the heater with a wooden mantel, shelf or other
combustible projection above, first measure the heat
resistant material shown in Figure 6, then refer to Table
B.
FP2532
mantel clear w hood
8" or More of Heat
Resistant Material
Hood
Heater in
Fireplace or
Firebox
FP53
Figure 6 -
Mantel Clearance with Hood
0" or more Hood not required. Figure 6
8" to less than 0" Install hood (CABR/CABL)
and refer to Figure 7;
extend heat resistant material
to at least 1" and refer to
Figure 8.
Less than 8" Extend heat resistant material
to at least 8" and install hood
(CABR/CABL), refer to
Figure 6. OR, extend heat
resistant material to a height
of at least 1" and refer to
Figure 8.
Table B -
Heat Resistant Material Heights and Mantel Location
8”
Min
13”
18”
20”
256O”
6” - 10”
12”
FP2534
Min. mantel w hood
Heat
Resistant
Material
Hood
Heater in Fireplace
or Firebox
FP534
Figure 7 -
Minimum Mantel Clearance with Hood
Example: A mantel may project from the wall a
of Z\x" at a of 13" above the opening and a
of 10" at a of 18" above the open-
ing.
20”
Min.
32”
10” or Less
FP2535
min mantel no hood
Heat
Resistant
Material
Heater in Fireplace
or Firebox
FP535
Figure 8 -
Minimum Mantel Clearance with No Hood
Example: The bottom of the mantel may project from the
wall a of 10" at a of 3" above the
opening.