Filter
Top Products
28
58D6056
CSDV Series Direct Vent Gas Stove
Figure 40
1. Carefully remove logs from wrapping.
2. Open front door of firebox.
3. Place rear log (#1) on rear log pins.
4. Place left base log (#2) on the two pins against left side
of firebox.
5. Place right base log (#3) on the two pins against right
side of firebox.
6. Place top left log (#4) on left base log. Line up the notch
in the bottom of the top log with the locator pins on the
bottom log.
7. Place top right log (#5) on right base log. Line up the
notch in the bottom of the top log with the locator pins
on the bottom log.
8. Rest one end top mid log (#6) on left base log and the
other on front burner.
PILOT
OFF
REMOTE CONTROL
LG818
CSDV40 Logs
Top Mid Log #6
Top Left
Log #4
Left Base
Log #2
Top Right
Log #5
Right Base
Log 33
Rear Log
#1
Pins
Pins
LG818
Figure 40 -
Place CSDV40 Logs
Break up rock wool (ember material) into dime-sized
pieces. Fluff up rock wool. Place rock wool evenly across
both burner surfaces. Do not block any areas around the
perimeter of the burner, as these are the areas that supply
the needed air for secondary combustion. Figure 41
PILOT
OFF
REMOTE CONTROL
LG819
CSDV40 rockwool
Rock Wool
LG819
Figure 41 -
Place CSDV40 Rock Wool