Moen 8901 Plumbing Product User Manual


 
INSTALLATION INSTRUCTIONS
THESE INSTRUCTIONS MUST BE
LEFT WITH HOMEOWNER
MODELS 4901, 8901
Measurements
Installs through 1-1/4" hole drillings on 4" centers.
Escutcheons diameters - 1-3/4".
Supplies are 3/8" O.D. copper tubing with 1/2" male
NPT nipple connedtions. Makes up to supply stops or
connec tions with flexible supplies.
The spout is not a swing spout. Fasten spout escutch-
eon securely before tightening the spout nut.
Equipped with flow control aerator.
BAR SINK FAUCET WITH
GOOSENECK SPOUT
10-3/4"
8-1/2"
3-1/2"
SPOUT
NUT
ESCUTCHEON
SPOUT
ASSEMBLY
HANDLE
HOUSING
HANDLE
LEVER
ESCUTCHEON
WASHER
SPACER
RETAINER
CLIP
MODEL 8901
NOTE: Maximum Deck
Thickness is 1/16".
CAUTION:
CLIP
EAR
CLIP
EAR
Always turn water off before disassembling the valve. Open valve
handle to relieve water pressure and insure that complete water shut-
off has been accomplished.
Before turning water on during either rough-in or trim-out, make sure that cartridge retainer clip is in place. The
cartridge and retainer clip were properly installed and tested before leaving the factory. Although it is unlikely,
it is nevertheless possible that through the handling of the valve by any number of persons the retainer clip
may not be properly installed. This should be carefully checked at time of rough-in and trim-out. If the retainer
clip is not properly installed, water pressure could force the cartridge out of the casting. Personal injury or water
damage to the premises could result.
®
Complies with ASME A112.18.1M and CSA B125
MT161A