Filter
Top Products
4 - 10
Chapter 4 Installation, Wiring and Maintenance of the Product
CAUTION
If the adhesion of solvent and oil to the cord part of SSCNET cable may lower the optical
characteristic and machine characteristic. If it is used such an environment, be sure to do the
protection measures to the cord part.
When keeping the Simple Motion module or servo amplifier, be sure to put on a cap to
connector part so that a dirt should not adhere to the end of SSCNET
connector.
SSCNET connector to connect the SSCNET cable is put a cap to protect light device
inside connector from dust. For this reason, do not remove a cap until just before connecting
SSCNET
cable. Then, when removing SSCNET cable, make sure to put a cap.
Keep the cap and the tube for protecting light cord end of SSCNET cable in a plastic bag
with a zipper of SSCNET
cable to prevent them from becoming dirty.
When exchanging the Simple Motion module or servo amplifier, make sure to put cap on
SSCNET
connector. When asking repair of Simple Motion module or servo amplifier for
some troubles, make also sure to put a cap on SSCNET
connector. When the connector is
not put a cap, the light device may be damaged at the transit. In this case, exchange and repair
of light device is required.