Filter
Top Products
Operating Instructions Client Reference
81
❒ If you do not want to install the printer when [
Found New Hardware Wizard
] starts with an operating
system, which supports SCSI print, inactivate the device by following the procedures.
A In [Found New Hardware Wizard] dialog box, and then click [Next>].
B When the [This wizard will complete the installation for this Device: Unknown] message ap-
pears, and select [Search for a suitable driver for my device [recommended]], and then click
[Next>].
C When the [Locate Driver Files] message appears, remove all the selections from [Optional
search locations.], and then click [Next>].
D When the [Driver Files Search Results] message appears, select the [Disable the device. The
Add/Remove Hardware Wizard in the control Panel can be able to complete the driver installa-
tions.] check box, and then click [Finish].
❒ When [
Found New Hardware Wizard
] appears every time you restart the computer with an operating
system which does not support IP over 1394, plug in or take out the cable, inactivate the device
with the following procedure.
A In [Found New Hardware Wizard] dialog box, and then click [Next>].
B When the [This wizard will complete the installation for this Device:] message appears and "IP
over 1394" appears select [Search for a suitable driver for my device [recommended]], and then
click [Next>].
C When the [Locate Driver Files] message appears, remove all the selections from [Optional
search locations.], and then click [Next>].
D When the [Driver Files Search Results] message appears, select the [Disable the device. The
Add/Remove Hardware Wizard in the control Panel can be able to complete the driver installa-
tions.] check box, and then click [Finish].