Filter
Top Products
FITTING:
1. Place the rear cage on the ventilator head (3 pins on the
ventilator head fit into 3 holes on the rear cage).
2. Screw the rear cage on so that it fits tightly to the ventilator
head (turn the lock (3) clockwise).
3. Put the blade on the motor shaft (one pin on the motor shaft
fits into 2 holes on the rear of the blade).
4. Put the blade lock (6) on the motor shaft and tighten it so the
blade is tightly attached (turn the lock clockwise).
5. Place the front cage together with the rear cage by first
hooking it tight at the top. Attach the front cage by clicking the
clips down over the edge of the front and back cages. Then
tighten the back and front cages together with the small screw
and nut.
6. Make the 2 feet form a cross and then screw the stand firmly
to the feet with the 4 accompanying screws. Attach the base
cap down over the feet.
7. Tighten the height adjustment ring.
8. Place the top section on the stand and tighten the fastening
screw.
USE:
WARNING:
In order to reduce the risk of fire or electric shock, never use the
appliance together with an electronic timer.
Speed:
Select the speed using the buttons on the control panel.
Press "0" to switch the fan off. Press "1", "2" or "3" to select the
speed.
Rotation:
The fan can turn from side to side or can be locked in a specific
direction by using the oscillation button on top of the fan head.
Press the button to start the fan turning and pull it up against to
stop it turning.
In order to select a particular direction for the fan to blow in, lift the
oscillation button and turn the fan head.
Vertical (up/down) control of the fan head:
In order to adjust the angle of the fan head vertically, tilt the fan
head up and down.
Adjusting the height:
To adjust the height of the floor fan, loosen the height adjustment
ring and pull the fan up and down. When the required height is
reached, tighten the ring again.
CLEANING
• Always switch the fan off and unplug it before cleaning.
• Clean the plastic parts using a damp cloth and a mild
detergent, and ensure that all detergent residue is removed.
• Never use abrasive cleaning agents or solvents.
• Do not immerse in any form of liquid.
THE GUARANTEE DOES NOT APPLY
• If the instructions given above are not observed.
• If the appliance has been mishandled, subjected to rough
treatment, or has suffered any other form of damage.
• For faults that may have arisen as a result of faults in your
electricity supply.
• If the appliance has been subject to unauthorised repairs.
Due to the constant development of our products in terms of
function and design, we reserve the right to make changes to the
product without prior warning.
IMPORTER
Adexi Group
We cannot be held responsible for any printing errors.
11
FT40P_IM6 22/12/04 13:59 Side 11