Filter
Top Products
E
H
G
F
A
D
C
A
Tr oubleshooting (cont’d)
A
B
C
D
E
F
G
H
*NOTE: To check where threaded portion enters tank,
insert cotton swab between jacket opening and fitting. If
cotton is wet, follow “Draining” instructions in the
“Service and Maintenance” section and then remove fit-
ting. Put pipe dope or teflon tape on the threads and
replace. Then follow “Filling the Water Heater” instruc-
tions in the “Instructions for Installation” section.
Leakage Checkpoints
Use this guide to check a “Leaking” water heater. Many sus-
pected “Leakers” are not leaking tanks. Often the source of
the water can be found and corrected.
If you are not thoroughly familiar with electric codes, the
water heater, and safety practices, contact your local utility or
call Maytag Customer Service at 1-800-788-8899 for an
authorized servicer to check the water heater.
CAUTION
Read this manual first, then before checking the
water heater make sure the electric supply has been
turned “OFF”, and never turn the electric supply
“ON” before the tank is completely full of water.
35
E
WARNING
HAZARD OF ELECTRICAL SHOCK! Before
removing any access panels or servicing the
water heater, make sure the electrical supply
to the water heater is turned “OFF”. Failure to
do this could result in DEATH, SERIOUS BODI-
LY INJURY, OR PROPERTY DAMAGE.
B
Turn electrical power “OFF”, remove access panels
and insulation pad. If leaking around elements, fol-
low proper draining instructions and remove ele-
ment. Reposition or replace gasket on element. Place
element into opening and tighten securely. Then fol-
low “Filling the Water Heater” instructions in the
“Instructions for Installation” section.
Water from drain valve may be due to the valve being
opened slightly.
*The drain valve may be leaking at the tank fitting.
*Water in the water heater bottom or on the floor may
be from condensation, loose connections or the tem-
perature-pressure relief valve. DO NOT replace the
water heater until a full inspection of all possible
water sources is made and necessary corrective steps
taken.
Leakage from other appliances, water lines, or
ground seepage should also be checked.
*Condensation may be seen on pipes in humid
weather or pipe connections may be leaking.
* The primary anode rod may be leaking.
Small amounts of water from temperature-pressure
relief valve may be due to thermal expansion or high
water pressure in your area.
* The temperature-pressure relief valve may be leaking
at the tank fitting.
The elements may be leaking at the tank fitting.