Maytag HN51240X Water Heater User Manual


 
Troubleshooting (cont'd)
Leakage Checkpoints
Use this guide to check a "Leaking" water heater. Many sus- _i CAUTION ]
pected"Leakers" arenot leaking tanks. Often the sourceof the Read this manual first. Then before checkingthe
water canbe found and corrected, water heater make sure the gas supply hasbeen ]
turned HOFF", and never turn the gas HOW' before
If you are not thoroughly familiar with your local gas codes the tank s completely full of water.
your water heater, and safety practices, contact your local gas
utifity or call Maytag Customer Service at 1-800-788-8899 _kCAUTION
for an authorized servicer to check the water heater. Never use this water heater unless it is completely [
filled with water. Toprevent damage to the tank, I
the tank must be filledwith water. Water must flow
from the hot water faucet before turning "ON" gas
to the water heater. I
_ Water at the draft hood is water vapor which has con-
densed out of the combustion products. This is caused by
a problem in the vent. Call Maytag Customer Service at
1-800-788-8899 for an authorized servicer.
O *Condensation be on pipes in humid weather
may
seen
or pipe connections may be leaking.
O'The primary anode rod fitting may be leaking.
O Smafi amounts of water from relief
temperature-pressure
valve may be due to thermal expansion or high water
pressure in your area.
O* The temperature-pressure relief valve may be leaking at
the tank fitting.
O Water from a drain valve be due to the valve opened
may
slightly.
O'The drain valve may be leaking at the tank fitting.
Combustion products contain water which can
vapor
condense on the cooler surfaces of the tank. Droplets
form and drip into the fire or run on the floor. This is
common at the time ofstartup after installation and
when incoming water is cold.
O Water in the heater bottom the floor be
water or on
may
from condensation, loose connections, orthe relief valve.
DO NOT replace the water heater until a full inspection
of all possible water sources is made and necessary cor-
rective steps taken. Leakage from other appliances, water
lines, or ground seepage should also be checked.
O *NOTE:To check where threaded portion enters tank,
insert cotton swab between jacket opening and fitting. If
cotton is wet, follow "Draining" instructions in the
"Service and Maintenance" section and then remove fit-
ring. Put pipe dope or teflon tape on the threads and
replace. Then follow "Filling the Water Heater" instruc-
tions in the "Instructions for Installation" section.
28