Filter
Top Products
Instructions for Installation (cont'd)
Installation Checklist
1. Whether or not the element conversion is made, the
model rating plate must be marked. Using a hard point H_OT __...._ _ COLD
ink pen, check the appropriate block within the model rat- _
ing plate, which is located adjacent to the lower access
panel.
2. Is the fuse or circuit breaker size correct as shown in the
chart m the Product Specifications section. CONDUIT - I
TEMPERATURE-
3. Are the wires from the circuit breaker or fuse service to the / PRESSURE
/
RELIEFVALVE
water heater's junction box on the correct wire size (gauge)
as shown in the chart in the "Product Specifications" sec-
tion?
4. Is the new temperature-pressure relief valve properly --DISCHARGEPIPE
(Donotcapor
installed, and piped to an adequate drain? See plug)
"Temperature-Pressure Refief Valve" in the "Instructions
for Installation" section.
5. Is the water heater completely filled with water? See
"Filling the Water Heater" instructions in the
Instructmns for Installatton sectton.
6. Will a water leak damage anything? See "Locating the I 6"AIR GAP
New Water Heater" in the "Instructions for Installation"
section.
FLOORDRAIN
7. Are the cold and hot water lines connected to the water
heater correctly? See "Water Piping" instructions in the
Instructzons for InstaUatmn section.
8. Is there adequate clearance for maintenance around the
water beater?
9. If the programmable thermostat has been moved to a
remote location, has the wiring been done correctly?
10. Do you need to call your electric company to check your '_ _* ,,_,'_,_
wiring? _ " _ w_
I_I_IqUCTION
® MaytegisaTrac_nerk olMayt_l Cotporabon
isused Und¢_-Lk_*.iso*o8tale InduslT_es,Ino
MODEL RATING PLATE
22