Maytag HE21282PC Water Heater User Manual


 
Instructions for Installation (cont'd)
29. Fasten wall plate loosely to the wall in position shown using _. CAUTION
the three screws provided in the plastic bag. Wall anchors are The six colored insulated wires must be installed in
recommended for drywall installation. Place a level on top of the terminal connector exactly as shown for the
the wall plate, adjust until level, and then tighten screws to thermostat to operate correctly.
secure wall plate.
_"--_"_-_ 32. Carefully plug the wired terminal connector to the mating
WALL _ pins on the thermostat back. Connector will install in one
direction only as shown.
_-_rrH ERMOSTA_-_,, 5
O.NGE/WH,TET.E--O TAT
SCREWS ._ ORANGI_'_I_ GREEN
GREEN/WHITE
30. Strip the remote thermostat cable outer insulation back 11/4 TERMINAL
inches. Strip the ends V4inch on each of the six colored wires. CONNECTOR
33. Place thermostat over wall plate, press firmly, and thermostat
,W-- _. ua _.250" will snap into place on the wall plate.
zH _H _1 _II_HmH_ ,
,.i -
31. Using the terminal connector removed in Step 12, insert the
six colored insulated wires in the remote thermostat cable
into the numbered slots in the terminal connector and tight- 34. Turn "ON" electric power m water heater.
en each screw to secure each wire. Be sure to arrange wires in
exact color sequence as shown.
6-WlRECABLEI_0iz_--" t_1_ _ua_--_"_"
TERMINAL
i 5 I_ 2 _I__._,_CONNECTOR
I _ _ qI & _ _- 35. Read Temperature Regulation Warning and Temperature
TERMINAL ( ( THERMOSTAT Settings, then proceed to Programming the Thermostat.
CONNECTOR _E
21