Filter
Top Products
Instructions for Installation (cont'd)
16. Find the loop of thermostat wiring cable (grey colored) inside 19. Strip the thermostat cable outer insulation back I_A inches.
the junction box and pull it out. Strip the ends % inch on each of the six colored wires.
LOOP _ m ud
__ J_ O _ ._ 1.250"
20. A second terminal connector is provided in a small bag con-
tained within the large plastic manual envelope attached to
the side of the water heater. Loosen each screw in the termi-
nal connector. Insert the six colored wires of the thermostat
17. Cut the thermostat wiring cable in half at the top of the loop. cable into the terminal connector and tighten each screw to
secure each wire. Be sure to arrange wires in exact color
sequence asshowm
6-WIRECA"LE
Lu _ =
z _ =
TERMINAL
6 A 2 1 _TCONNECTOR
TERMtNAL ( _ THERMOSTAT
CONNECTOR _E
18. The wire side of the loop which does not have the red tape
strip on it should be cut off or pressed into the junction box
out of the way. A CAUTION
The six colored insulated wires must be installed in
the terminal connector exactly as shown for the
thermostat to operate correctly.
I TH_AT 21. Locate the end of the remote thermostat cable routed to the
water heater in Step 8.
R_RTIApPE
ACTIc_ ALF
19