Filter
Top Products
AM-KPI
Access
Control
Keypad
Installation
Instructions
1. INTRODUCTION
The Model AM-KPI keypad is designed for use with Linear’s
AE1000Plus, AE2000Plus, and AM3Plus access control systems. The
keypad is housed in a rugged, plastic enclosure and is designed to
be mounted indoors in a standard single-gang electrical box. Tamper
resistant screws secure the keypad to its mounting plate. The die-cast
keys have bright, easy-to-read yellow graphics.
The keypad is supplied with a satin-chrome plastic bezel installed.
Three interchangeable colored plastic bezels (white, ivory, & bronze)
are included with the unit to customize the keypad appearance for the
installation.
All system indicators and lights are long-lasting, solid-state LEDs. Two
indicators show the status of the entry system. The left indicator lights
red to indicate power, then turns green when access is granted. The
right indicator lights yellow when the keypad is in “lockout” condition
(from too many incorrect code entries). A white LED downlight lights
the keypad for nighttime use. An internal sounder beeps when each
key is pressed.
The AM-KPI is normally powered from the controller. Alternately,
the keypad can be powered locally with a 12 VDC power supply.
Robust static and lightning protection circuits safeguard the keypad’s
electronics.
A rotary switch selects the keypad’s PBUS device address. Each
device connected to the controller must be set to a different PBUS
device address.
2. KEYPAD FEATURES
3. OPEN THE KEYPAD 4. CUSTOMIZE THE BEZEL (OPTIONAL) 5. INSTALL WALL BOX & MOUNTING PLATE
USA & Canada (800) 421-1587 & (800) 392-0123
(760) 438-7000 - Toll Free FAX (800) 468-1340
www.linearcorp.com
PRINTER’S INSTRUCTIONS:
INSTR,INSTL,AM-KPI - LINEAR P/N: 218940 B - INK: BLACK - MATERIAL: 20 LB. MEAD BOND - SIZE: 11.000” X 8.500” - SCALE: 1-1 - SIDE 1 OF 2
RED/GREEN
POWER/ACCESS
INDICATOR
YELLOW
"LOCKOUT"
INDICATOR
KEYPAD
SOLID STATE
WHITE LED
DOWN LIGHT
FACEPLATE
BEZEL
MOUNTING
PLATE
TERMINAL
BLOCK
PBUS
DEVICE
ADDRESS
SELECTOR
KEYPAD
BEZEL
•
SATIN-CHROME (FACTORY INSTALLED)
•
WHITE
•
IVORY
•
BRONZE
KEYPAD BEZEL COLORS:
THE BEZEL SNAPS
ONTO THE KEYPAD
ASSEMBLY
KEYPAD
ASSEMBLY
TO CHANGE THE APPEARANCE OF THE KEYPAD
TO BLEND IN WITH THE INSTALLATION,
CHOOSE THE APPROPRIATE KEYPAD BEZEL
1
2
3
4
PRY UP THE
FACEPLATE HERE
REMOVE THE
FACEPLATE
REMOVE THE
TWO SCREWS
MOUNTING
PLATE
SEPARATE THE
MOUNTING PLATE
FROM THE KEYPAD
INSTALL A SINGLE-GANG
ELECTRICAL BOX AT THE
PROPER LOCATION
FOR THE KEYPAD
ATTACH THE MOUNTING
PLATE TO THE
ELECTRICAL BOX
MAKE SURE THE
TAB IS UP
MOUNTING
PLATE