Lightolier LSBW-8 Indoor Furnishings User Manual


  Open as PDF
of 2
 
Job Information Type:
Job Name:
Cat. No.:
Lamp(s):
Notes:
"JSQPSU3PBE'BMM3JWFS."tt'BY
We reserve the right to change details of design, materials and finish.
XXXMJHIUPMJFSDPN½1IJMJQT(SPVQt
Lighting Systems LSBW-8
1BHFPG -ZUFTQSFBEÜ-4#1JFSDFE8BMM.PVOU-JHIU51FS'PPU/PNJOBM4FDUJPO
$
Features
1. Housing: Extruded aluminum. Die-cast end cap mechanically attached with
no exposed fasteners or hardware.
2. Lamping: Two T8, 32 watt fluorescent lamps per 4-foot nominal section.
Provided by others.
3. Reflector: Precision die-formed, semi-specular aluminum.
Electrical
Ballast - <10% T.H.D., .98 ballast factor, pre-heat start. 18 gauge wire. Color-
coded quick connectors allow ease of connection for joiner modules. For special
circuiting, consult factory. Factory installed ballast disconnect allows the ballast
to be disconnected from and reconnected to incoming power under load without
turning the entire circuit off.
Dimming - 120/277 VAC, 1% dimming level.
Emergency Battery Pack - 32 Watt: 450 Lumens @ 90 min.
4 wire feed required.
Ordering Instructions
Individual Fixtures:
1. Order number of MODULES required.
2. Order one END SET per MODULE.
Continuous Rows:
1. Determine run length.
2. Order the appropriate number of MODULES to complete the run.
3. Order one END SET per run.
Labels
UL, cUL and I.B.E.W.
Complete ordering instructions below.
Ordering Information
Type Lamps Length Shielding Ballast Voltage Finish
2 = 2-Lamp T8 4 = 4-Foot B = Pierced 32 = 32W T8 1 = 120 Volt AL = Aluminum
8 = 8-Foot 3E = 32W Emergency Pack 2 = 277 Volt WH = White
3D = 32W Dimming
LSBW 2 B
Mountings
Dual-screw, draw-tight connector to create hairline seam between joiner modules.
Finish
Powder coated baked white or aluminum finish.
Custom colors available, consult factory.
4. Shielding: Precision die-formed, pierced 20 gauges CRS Piercing is four rows
that extend the entire length of the lamps. The pattern is 5/8” (1.59cm) x 1/16”
(0.16cm) slot with a 3/16” (0.48cm) separation between rows.
11-3/8" (28.89cm)
8-1/2" (21.59cm)
1-3/4"
(4.45cm)
3-1/2" (8.89cm)
12 3
4
Pierce Pattern
1/16" (0.16cm)
5/8" (1.59cm)
3-1/16" (7.78cm)
3/16" (0.48cm)