Lightolier IS:5543 Indoor Furnishings User Manual


  Open as PDF
of 1
 
READAND UNDERSTANDTHESEINSTRUCTIONSBEFOREINSTALLINGFIXTURE
INSTRUCTION SHEET NO.
sfixtureisintendedforinstallationinacmrdanmwiththeNational
Electrical Code and IOCSIregulations.
assure full mmpfiance with local @ales and regulations, deck with your Iocsl electrical inspector before
,allation.
To prevent electrical shock, turn off electrify at fuse box before proceeding.
IS:5543
Retain these instructions for maintenance reference,
1292 Page 1 of 1
INSTRUCTIONS FOR INSTALLATION
XTURE ASSEMBLY AND INSTALLATION:
1, Thread MOUNTING SCREWS intoOUTLET BOX.
2, Wtile supportingCEILING PANmake
electrical connections black fixture lead orfixlureleadwithouttracermarksto(hot)blacksupplylead;white fixturelead
orfixtureleadwithtracer mark10(neutral)whitesupplylead.Uninsulatedwire isa groundandmustbeconnectedtogroundhgtarminalorgroundleadinside
OUTLET BOX, Use WIF?ENUTS(localhardware
item). Push supply wiresandwirenutmnnecfions backintoOUTLET BOX.
3. PositionCEILING PANoverMOUNTING SCREWS andallowheadsofMOUNTING SCREWS tocomethroughtheKEYHOLE SLOTS inCEILING PAN.Secure
in place by tightening MOUNTING SCREWS,
4, Using the thrae AUXILIARY MOUNTING HOLES in CEILING PAN, secure CEILING PAN to ceiing using wood screws, toggle bolls,
oralternate fasleners (not
provided) depending on ceiling material,
5, lnstdl recommend lamps by inseiling base of lamp into SOCKET and snapping lamp into LAMP SUPPORT CLIP,
CAUTION Use lamp waftage and type as marked on fixture,
6, Align holes in
DIFFUSERRINGASSEMBLYwithMOUNTINGSTUDSonCEILINGPANandallowSTUDStopasslhroughlheholes.Secure in place bylhreadhg
KNOBS onto each MOUNTING STUDS,
)IFFUSER CLEANING AND REMOVAL:
)iffusercan be cleaned using a soft damp cloth, Should DIFFUSER need to be removed
.om diffuser ring for cleaning, follow steps below.
Whie gently pving back on one RETAINING SPRING (use a slotted screw diver)
push upon OIFFUSER allowing DIFFUSER to snap away from three RETAINING
SPRING (Ffg, 2).
!.’ Clean DIFFUSER.
1,’ Reinsfdl DIFFUSER bygeotly pushing DIFFUSER down into DIFFUSER RING until
all three RETAfNING SPRINGS engage on the edge of Ihe DIFFUSER and
DIFFUSER sits flush inside DIFFUSER RING.
NOTE: If supply wires are locatedwithin three inchesof
ballast, usewire rated
for at least 90° C.
WARNING-(RISK OF FIRE) MOST DWELLINGS
BUILT BEFORE 1985 HAVE SUPPLY WIRE RATED
60” C. CONSULT A QUALIFIED ELECTRICIAN
BEFORE INSTALLATION.
DIFFu
FIG. i
1.1<5
I“ITC>I.IE la”EWH’,!W%YU