Filter
Top Products
INSTRUCTION SHEET NO
INSTRUCTIONS PROCEDURE FOR LOW VOLTAGE
FRAME=fN KIT WITH REM~E TRANSFORMER
IS:2000LVNT
0191
Page 1 of 2
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.
This fixture is intended for installation in accordance with the National Electrical Code or local regulations. To
asaure full compliance with local codes and regulations,
check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference
N~E FRAME-fN KIT IS PROVIDED WITHOUT TRANSFORMER. TRANSFORMER MUST BE PROVIDED SY
OTNERB. LIGHlOLIER CAT #B60S AND 8609 TRANSFORMERS MAy BE USED.
CAUTION: THIS FRAME-IN KIT IS RATED AT 42VA. USE ONLY 12V. AC. INPUT.
FIG. A
FIG. B FIG. C
FIG. D
1. FRAME-IN
2. CLOSE-IN
3. SNAPON
4. PUSH-UP
WARNING—(RISK OF FIRE) DO NOT INSTALL INSULATION WITHIN 3 INCHES OF FiXTURE SIDES OR
WIRING COMPARTMENT, NOR ABOVE FIKTURE IN SUCH A MANNER TO ENTRAP HEAT.
1.
2.
3.
4.
FRAME.IN (Fig. A)
Faaten MOUNTING FRAME to wood joist. Line
N~E For wat plaster ceiling, uae Plaster
Ring Accessory No. 1959 (order aaparately).
4&=---- ‘OTO”cL’p
SNAPIN (Fig. C).
I
SEE SEPARATE
REFLECTOR TRIM
PUSH-UP (Fig. D).
INSTRUCTION
SHEETS.
FIG G
SEE BACK PAGE FOR LAMPING INSTRUCTIONS.
LK59-ITC>949
[=@sEcAucus> NEw JERSEY,07096
* MO NT REAL, QUEBEC, C AN ADA
L