Lightolier IS:1161-A Indoor Furnishings User Manual


  Open as PDF
of 2
 
INSTRUCTION SHEET NO.
\
THIS REFLECTOR TRIM MUST BE INSTALLED
IN LIGHTOLIER’S
1100 SERIES FRAME-IN.KIT ONLY
IS:1161A
06w
Page 1 of 2
:EAD AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.
~is fixture is intended for installation in accordance with the National Electrical Code and local regulations.
3 assure full compliance with local codes and regulation, check with your local electrical inspector before
lstallation.
To prevent electrical shock, turn off electricity at fuse box before proceeding.
stain thasa Inatructlona for maintananca reference.
IOTE Uaa this Instruction Sheet only when Lytecaatar Reflectcr Trim ie being instelled in the 1100 series
kama-hr-f(its with ROTO.CLIPS (ace Fig. E). If not, disregard this Instruction Sheet. N is reccmmanded YCU
naintein e copy of the following instructions for reference.
%gE=
FIG. A
FIG. B
FIG. C
FIG. D
1. FRAME-IN 2. ROTATE CLIPS
3. SNAP.ON
4. PUSH.UP
WARNING: BEFORE INSTALLING REFLECTOR TRIM TO FRAME4N KIT, READ MARKINGS IN REFLECTOR TRIM
AND IN SOCK= CUP OF FRAME4N.KIT TO D~RMiNE LAMP WAlTAGE AND TYPE APPLICABLE FOR YOUR
iNSTALLATION. IF LC. TYPE FRAMING KfT IS USED, iT MAY BE INSTALLED IN DIRECT CONTACT WITN lNSUfATED
CEIUNGS. IF A NON LC. lYPE FRAME4N4(iT IS USED, 00 NOT INBTAU lNSULATfON WiTHiN 31NCHSS OF FfXIWRE
SIDE OR WIRING COMPARTMENT, NOR ABOVE FfXTURE IN SUCH A MANNER TO ENTRAP HEAT.
1. FRAME.IN (Fig. A)
See Freme-in-Kit instruction Sheets, for
installation procedure.
2. ROTATE ROTO-CLIPS (Fig. B)
Rotate (4) ROTO CLIPS so that the shofi legs
extend inwardly toward the center opening
g:’’LqLO”GLEG
(Fig. F).
‘-” FIG. E
. ..-..,.:.
NOTE The SHORT LEG cf the ROTO CLIP haa
FIG. F ‘-’:::~..,
NO return on top. (Fig. E & F).
‘RIM INSTALLATION
3. Insert HOOK in ear of SPRING on SOCKET
CUP and let HOUSING hang down (Fig. H).
Straw SOCKET EXTENSION (MALE ADAPTER)
into SOCKET in SOCKET CUP.
HOUSING
4. Disengage HOUSING from SOCKET CUP
by FIG. G
pulling HOOK out of SPRING ear (Fig. G). Insert
SOCKET CUP between tabs on MOUNTING
BRACKET, making sure SPRINGS snaps into
slote of MOUNTING BRACKET (Fig. C).
5. Tilt HOUSING and insert SOCKET CUP into
ceiling openin on side opposite junction box,
8pivot HOUSIN and push it up into ceiling until
flange on HOUSING is flush to ceiling (Fig. D).
SEE BACK FOR LAMP INSTALLATION AND ADJUSTMENT
U.S. PATENT NO, 4,&ZW244,3f3,154 end 4,32T#Gl
HO
FOREIGN PATENT3 PENDING.
FIG. H
[m
K5+1TC>IJE R“:v:::::i,N::