Filter
Top Products
Lightolier is a Philips group brand
631 Airport Road, Fall River, MA 02720 • (508) 679-8131 • Fax (508) 674-4710
We reserve the right to change details of design, materials and finish.
www.lightolier.com © 2008 Philips Group • F0708
Job Information Type:
Job Name:
Cat. No.:
Lamp(s):
Notes:
Calculite
®
Evolution Non-IC Airseal
®
Frame C4ALV
Page 1 of 1 4" Aperture, MR16 (12V)
For Complete Fixture Order: Trim Kit + Frame-In Kit. Each Sold Separately.
Frame-In Kit Reflector Trim
C4ALVMU
Magnetic 120V/277V
Open
Downlight
Adjustable
Accent
Adjustable
2" Aperture
Adjustable
1 1/4" Pinhole
Lensed
Wall Washer
Glasslyte
Downlight
Glasslight
Adjustable
Lensed
Adjustable
C4ALVE1
Electronic 120V
C4MRD
42W-75W
MR16 (12V)
C4MRA
42W-75W
MR16 (12V)
C4MR2
42W-75W
MR16 (12V)
C4MRP
42W-75W
MR16 (12V)
C4MRL
42W-75W
MR16 (12V)
C4MRGD
42W-75W
MR16 (12V)
C4MRGA
42W-75W
MR16 (12V)
C4MRW
42W-75W
MR16 (12V)
Note: Magnetic transformers may produce audible sound when used with dimmers, which may be objectionable in acoustically critical areas.
Features
1. Housing: Drawn, 0.036" (20 Gauge) steel. Matte black finish. Housing
minimizes air leakage to less than 2 CFM (Cubic Feet per Minute) at 1.57
PSF (Pounds per Square Foot) (or 75 Pascals), which complies with Model
Energy Code and Washington State Energy Code and reduces heat loss and
condensation in ceiling.
2. Mounting Frame: Die-formed, 0.036" (20 Gauge) steel, matte black finish.
Four slots are positioned 90° apart to simplify alignment.
3. Retaining Springs: Steel springs secure reflector trim to mounting frame
for tool-less installation.
4. Mounting Bars: Galvanized steel, 0.059" (16 Gauge). Bars pivot for
attachment and wire-in below ceiling line. Pre-installed telescoping bars
extend to accommodate 16" to 24" on center joist spacing. Integral screws
for secure attachment to wood; attach to T-bar ceilings without the need for
accessories.
5. Lampholder: Porcelain bi-pin socket. Pre-wired with Teflon leads.
6. Junction Box: 3-1/2" X 4" X 2-3/8" deep; 0.063 (14 Gauge) galvanized
steel. UL listed for maximum of (4) No. 12 AWG (American Wire Gauge) 90°
C through branch circuit conductors. Accessible from inside and outside
luminaire. Outside J-Box door is hinged for maximum access.
7. Thermal Protector: Meets NEC and UL requirements. Insulation must be
kept 3" away from any part of the luminaire and must not be placed above
luminaire in a manner which will entrap heat.
Electrical:
Transformer: Replaceable from below; transformer door rotates into fixture,
positioning transformer directly over the aperture. Magnetic: 120V/277V 60Hz.
dual-voltage, core & coil. Electronic: 120V or 277V 50/60 Hz., regulated lamp
voltage, HPF (High Power Factor), EMI (Electro Magnetic Interference) and short
circuit protections, thermal auto-reset, quiet operation.
Electrical (cont.)
Dimming Controls: Use only dimmers specifically designed for use with
magnetic or electronic transformers. Consult Lightolier Controls division for
information. Low voltage luminaries may produce audible sound when used with
dimmers.
Accessories
Thick Ceiling Adapter: for .875" - 1.75" thick ceiling capability, utilize C47CA2
Labels
CULUS (Suitable For Damp Locations), U.S. & Foreign Patents pending. Complies
with Air Leakage Requirements as stated in the Model Energy Code and the
Washington State Energy Code.
123 4567
1/2" (13mm) Lip
Vertical Adjustment
1" (25mm)
to 2 3/4" (70mm)
.875" Max (28mm)
Ceiling Thickness
5" (127mm)
Plus Ceiling Thk.
5 1/2"
(140mm)
9 5/8"
(245mm)
5" (127mm)
14 3/8"
(365mm)
Ceiling Cutout: 5 1/16" (129 mm) Dia.