Filter
Top Products
Lytespan
®
Accent Lighting System 8606WH
Page 1 of 1 LyteJacks Point Power Jack From Below Ceiling
Job Information Type:
Job Name:
Cat. No.:
Lamp(s):
Notes:
Lightolier a Genlyte Thomas Company www.lightolier.com
631 Airport Road, Fall River, MA 02720 • (508) 679-8131 • Fax (508) 674-4710
We reserve the right to change details of design, materials and finish.
© 2002 Genlyte Thomas Group LLC (Lightolier Division) • A0902
Features
1. Power Plug Housing: Die-cast aluminum; contains female jack connector,
3/4-14 outer thread.
2. Clamping Wings: Aluminum die-casting. Clamp down on ceiling to support
fixture.
3. Splice Compartment Base: Zinc die-casting. Provides base for splice cover
and retains mounting screws.
4. Splice Compartment Cover: Formed .04” thick aluminum, encloses splices.
5. Molded Cap: Flame retardant ABS, snaps onto aluminum die-casting.
6. Female Plug Jack: High heat resistant thermoplastic contains electrical
components to operate LyteJack fixtures.
7. Anti-Short Bushing: By others.
8. 16 Ga. Teflon Coated Wire
9. Mounting Screw (2): 6-32 x 2 1/2” long.
10.075” Galvanized Steel Plate: Provides lower bearing on ceiling for fixture
support.
11.90° Eletrical Connector: Accepts supply conduit.
12.Center Bushing: Remove for Lytedrops.
Use either Lightolier remote transformer 8608 (75W) or 8609 (225W).
Accepts #12 to #16 ga. copper wire. To minimize voltage drop, mount Point
Power Jack(s) no farther than 8 ft. from transformer. For multiple Power Jacks,
wire each directly to the transformer with the same length and gauge of wire to
minimize voltage drop differences between Point Jacks. Connect flexible conduit
to 90° connector. Use conventional wirenuts to splice leads in the splice
compartment.
Labels
UL; I.B.E.W.
Patents
Products shown here are protected by applicable patents and patents pending.
Catalog No. Finishes Mounting
8606WH Matte White To existing structurally sturdy ceilings, 1/8” to 1 1/2” thick (Non-Accessible)
For: Focal Jacks and Style Jacks