Filter
Top Products
MAINTENANCE
PAGE 18
Cleaning – If the chimney is to be cleaned without re-
moving the insert from the fireplace, the baffle plate (in
the firebox) must first be removed. Chimney cleaning
should only be done by a qualified chimney sweep. See
following – Cleaning / Removing Baffle Plate.
Cleaning / Removing Baffle Plate - To remove, locate
the 3 secondary air tubes, which support the baffle in the
upper firebox. They are secured in place by one bolt
each at the point where they meet the left wall. Remove
bolt and slide tube to the right until it releases. Remove
all 3 tubes this way. Next slide the baffle plate all the way
to one side until it will drop diagonally into lower firebox.
Remove baffle plate through door opening (diagonally).
WARNING! DO NOT OPERATE THE INSERT WITH-
OUT THE BAFFLE PLATE PROPERLY INSTALLED.
THIS WILL VOID WARRANTY
In the event of a chimney fire - Make sure the fuel door
is securely closed. Adjust the primary air control to the
lowest (most closed) setting. Call the fire department
immediately. After a chimney fire, the complete chimney
system should be checked by a qualified technician be-
fore further use.
Consult your dealer for suggestions on proper chimney
care. Contact your local municipal or provincial fire au-
thority for information on how to handle a chimney fire.
Have a clearly understood plan for handling a chimney
fire.
REINSTALL BAFFLE PLATE
After your chimney has been swept, reinstall the baffle
plate. See – Cleaning / Removing Baffle Plate above and
reverse steps.