Lexmark 3300 All in One Printer User Manual


 
Remove the sticker and tape
from the print cartridges.
8
1
2
1
2
1
2
3
Unpack your All-In-One.
Note: Contents may vary based on geography.
1
Note: You may need to purchase a USB
cable separately.
www.lexmark.co
m
3300 Series All-In-One
Connect the power cord to the power supply.
2
2
1
Lift the paper support and extend
the paper exit tray.
5
6
2
1
3
See the troubleshooting guide on the reverse of this sheet.
Make sure the power light is on.
3
Lift the scanner unit.
7
Close the scanner unit.
10
1
2
3
Your All-In-One may include a
photo cartridge instead of a
black print cartridge.
Before you continue, remove the
photo cartridge from the print
cartridge storage unit.
Note: Save the print cartridge
storage unit to protect any open
cartridges not in use.
Press to scroll to your language
and then press .
4
1 Pull back the transparent deflector.
2 Load the paper flat and to the right.
3 Squeeze the paper guide. Slide it
to the right until it is snug.
1 Open the cartridge lids by pressing the front tabs.
2 Insert the cartridges and push them down firmly.
3 Snap the lids tight.
9
Press to print
an alignment page.
You may discard the page
after it prints.
11
Left:
photo
or
black
Right:
color
only
Steps 12–15
Safety information
CAUTION: Do not set up this product or make any electrical or cabling connections, such as the power supply cord or
telephone, during a lightning storm.
Use only the power supply provided with this product or the manufacturer's authorized replacement power supply.
Connect the power supply cord to an electrical outlet that is near the product and easily accessible.
Refer service or repairs, other than those described in the user documentation, to a professional service person.
*23A0170*