Filter
Top Products
GRANDVIEW™ BLOWER KIT
INSTALLATION INSTRUCTIONS FOR INSTALLING THE BLOWER
ON A GRANDVIEW™ 230 WOODSTOVE
P/N 506033-56
Rev. NC, 08/2011
HEARTH PRODUCTS
KITS AND ACCESSORIES
KIT CONTENTS
Please ensure that all these parts are included
1 ea. Blower w/snap switch assembly
6 ea. 10-24 Screws
4 ea. Tinnerman nuts
Grandview™ Blower Kit
Cat. No. Model Description
H8350 BLWR-GV-700-SS Blower
1
TOOLS NEEDED
Flat Head Screwdriver
5/32” Allen Wrench
1/8” Allen Wrench
GENERAL INFORMATION
If you encounter any problems, need clarification of these instructions or
are not qualified to properly install this kit, contact you local distributor
or dealer.
Read this instruction sheet in its entirety before beginning the installa-
tion.
ALL WARNINGS, PRECAUTIONS AND INSTRUCTIONS IN THE INSTAL-
LATION AND OPERATION MANUAL PROVIDED WITH THE APPLIANCE
APPLY TO THESE INSTRUCTIONS.
Check the contents of the kits upon receipt and check for any damaged
or missing parts. If there is hidden damage, notify your freight company
or Lennox Hearth Products dealer immediately.
CAUTION: Wear gloves during installation in case of sharp
edges on the stove.
INSTALLATION INSTRUCTIONS
Step 1. Remove round knockout plate on back of stove by removing the
screw on the top of the knockout with a 5/32” allen wrench. You
can then push on the top and bottom of the plate to loosen for
removal.
Step 2. Install the four supplied flat Tinnerman nuts into the four rect-
angular slots on the back of the stove. Use of a flat head screw
driver will be necessary.
Figure 1
Snap Switch
Tinnerman Nut
NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE.