Filter
Top Products
INSTALLATION INSTRUCTIONS FOR GLASS PANEL ENCLOSURE KITS
FOR USE WITH MODELS MPE-33R AND MPE-36R ELECTRIC FIREPLACES
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Printed in U.S.A LENNOX HEARTH PRODUCTS 2004
P/N 775,177M REV. A 12/2005 Page 1 of 1 1110 West Taft Avenue • Orange, CA 92865
LENNOX HEARTH PRODUCTS
KITS AND ACCESSORIES
Cat. No. Model Description
H1535 GEP-36BL Glass Enclosure Panel, Black on Bronze
H1536 GEP-36PB Glass Enclosure Panel, Brass on Bronze
H1537 GEP-36BS Glass Enclosure Panel, Stainless on Bronze
H3430 GEP-33BL Glass Enclosure Panel, Black on Bronze
H3433 GEP-33PB Glass Enclosure Panel, Brass on Bronze
H343
4
GE
P
-33BS Glass Enclosure Panel
,
Stainless on Bronze
775,177M Rev.
A
12/2005
LENNOX reserves the right to make changes at any time, without notice, in design, materials,
specifications, prices and also for discontinued colors, styles and products.
Consult your local distributor for fireplace code information
.
Figure 2
KIT CONTENTS:
1 ea. Glass Enclosure Panel
1 ea. Instructions Sheet
TOOLS REQUIRED:
None
INSTALLATION INSTRUCTIONS:
Ensure fireplace is cool to touch before starting installation.
Step 1. Remove the plastic protective coating from the trim
surfaces of the glass enclosure panel.
Step 2. Locate the slots on the bottom side edges of the fire-
place firebox opening and locate the tabs on the glass panel
enclosure (see Figure 2). Insert the 2 tabs on the glass panel
enclosure into the 2 corresponding slots on fireplace.
Step 3. Press the 2 latch buttons inward to retract locating pins
(see Figure 3). Rotate the top of the glass enclosure panel back
until it is flush with fireplace face. Release latch buttons, so pin
retract and engage into corresponding holes on fireplace.
Cleaning - Never clean glass when hot. Do NOT use ammonia or
ammonia based cleaners on glass or frame as it will damage the
finish. Remove dirt and grime from glass using a clean dampened
towel followed by wiping with a dry towel. To remove stubborn
stains, use a mild soap solution and towel to gently scrub away
stain. Take care not to scratch the glass surface. Do NOT use
abrasive cleaners.
Locate 1 Slot, each side
of firebox opening
Glass Panel
Fireplace
Locate 1 Tab, each
side of glass panel
Figure 4
Figure 1
Push latching button
inward until pin retracts
Completed Glass Panel Enclosure Installation
Figure 3