Filter
Top Products
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
9
Connecting The Power Vent To The Fireplace Control System
Remove any control compartment cover or access plates and set aside.
Ensure power is off to the fireplace.
Connecting To Battery Backed-up Dexen Systems
Refer to the general components layout shown in Figure 14.
• Disconnect and remove the battery pack. See Figures 15 and 16.
• Disconnect system power transformer (3V) from power outlet. Refer
to Figure 14.
• Disconnect 2 brown wires from the On/Off switch.
• Reconnect 2 brown wires to the control module (#4). See Figure 17.
Figure 14 General System Layout (Firebox Floor Removed For Clarity)
Figure 15
Figure 16
Control Module System Power Cord
Control Module (4)
On/Off Switch Pressure Switch (3) Power Outlets Control Module Power Cord
4 Wire Harness (2)Vacuum Hose (1)
System Power Transformer
Battery Pack (Remove) Disconnect Here
Disconnected Battery Pack
Bundle Disconnected Wire (Do Not Re-use)