Lasko 3637 Fan User Manual


 
Figura 1
Botón Función de
Temporizador
Botón
Velocidad
Botón
Alimentación
SAVE THESE INSTRUCTIONS
1. Make certain the power source conforms to the electrical requirements of the Fan.
2. Make certain that the room is equipped with a working smoke detector.
3. Use this Fan only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electrical shock,
or injury to persons.
4. To reduce the risk of personal injury and electric shock, the Fan should not be played with or placed where small children can reach it.
5. Unplug power cord before installing, servicing, or moving the Fan.
New 8/11
2
3637ES
DO NOT DEPEND ON THE ON/OFF SWITCH AS THE SOLE MEANS OF DISCONNECTING POWER WHEN SERVICING
OR MOVING THE FAN. ALWAYS UNPLUG THE POWER CORD. ALWAYS TURN OFF AND UNPLUG FAN BEFORE
LEAVING THE AREA. NEVER LEAVE CHILDREN UNATTENDED WHEN THE FAN IS ON OR PLUGGED IN.
6. This Fan must NOT be used in potentially dangerous locations such as flammable, explosive, chemical-laden or wet atmospheres
where gasoline, paint or flammable liquids are used or stored.
7. DO NOT use Fan in or near a window. Rain may create an electrical hazard.
New 8/11
7
3637ES
8. Where possible, avoid the use of extension cords because the extension cord may overheat and cause a fire. If you must use an exten-
sion cord, minimize the risk of overheating by using the shortest cord possible and ensuring that it is UL listed. NEVER use a single
extension cord to operate more than one Fan.
9. NEVER operate any Fan with a damaged cord or plug or after the Fan malfunctions, has been dropped or damaged in
any manner.
10. NEVER insert or allow fingers or foreign objects to enter any ventilation or exhaust opening as it may cause an electric shock or fire,
or damage the Fan. To reduce the risk of fire, DO NOT block or tamper with the Fan in any manner while it is in operation.
11. Always place the Fan on a stable, flat, level surface when operating, to avoid the chance of the Fan overturning. Locate the Power
Cord so the Fan or other objects are not resting on it. Do not run cord under carpeting. Do not cover cord with throw rugs, runners,
or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be
tripped over.
12. This Fan is not intended for use in wet or damp locations. Never locate a Fan where it may fall into a bathtub or other water container.
NEVER use Fan where flammable liquids are used or stored.
13. NEVER use Fan outdoors.
14. Remote controls for other appliances or electronic equipment can sometimes interfere with the operation of this Fan. If this occurs,
move the Fan to another location.
15. Keep Fan remote control unit away from chairs and your bed where it may be sat or laid upon and inadvertently turn on the Fan.
16. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. •
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an
experienced radio/TV technician for help.The user is cautioned that changes and modifications made to the equipment without the
approval of manufacturer could void the user’s authority to operate this equipment.
17. This Fan is not suitable for use in agricultural facilities including areas where livestock, poultry or other animals are confined. Please
refer to National Electric Code (NEC) Article 547-7 (2008), or applicable state or local codes or standards relating to electrical require-
ments for Agricultural Buildings. THIS FAN DOES NOT MEET THE REQUIREMENTS OF NEC ARTICLE 547-7 (2008).
18. This Fan is not suitable for use in hazardous locations. Please refer to National Electric Code (NEC) Article 500 or applicable state or
local codes or standards relating to electrical requirements for Hazardous locations. THIS FAN DOES NOT MEET THE REQUIRE-
MENTS OF NEC ARTICLE 500 (2008).
This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug
is intended to fit in a polarized outlet only one way. Match wide blade of plug to wide slot. Fully insert. If the plug does
not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. DO NOT attempt to defeat
this safety feature.
MODELO 3637
CONTROL REMOTO:
Todas las funciones realizadas con el Control Remoto funcionan
idénticamente a los controles manuales. (Figura 2).
1. Instale la baterías (no suministró) como mostrado en la Figura
2. La batería es tipo "AAA".
2.No mezcle baterías viejas y nuevas. No mezcle baterías
alcalinas, estándar (carbono-cinc) o recargables
(níquel-cadmio).
3.NO ARROJE LAS BATERÍAS AL FUEGO. LAS BATERÍAS PUEDEN
EXPLOTAR O SUFRIR PÉRDIDAS.
FUNCIONAMIENTO (Figura 1)
1. Cuidadosamente retire el Ventilador de la caja.
2. Coloque el ventilador sobre una superficie firme y nivelada.
ADVERTENCIA: Los tacos de plástico o hule, tales como las patas
de esta unidad, pueden pegarse a la superficie de los muebles.
La unidad podría dejar un residuo capaz de oscurecer, manchar
o dejar marcas permanentes en el acabado de ciertas superficies
de muebles, incluyendo superficies y pisos de madera.
3. Conecte el cable eléctrico a un tomacorriente de 120 V~.
Asegúrese que el enchufe encaje firmemente en el
tomacorriente.
Cuando los enchufes quedan flojos en los
tomacorrientes, pueden deslizarse parcial o
completamente fuera del tomacorriente con un leve
movimiento del cable adosado. Los tomacorrientes
en este estado podrían sobrecalentarse y
representar un grave peligro de incendio; si está
cubierto por una cortina o tela, el riesgo de incendio
es aún mayor.
4. Para ajustar la direccion del aire, simplemente jire la cabeza
del ventilador.
5. Conecte la energía eléctrica a su ventilador pulsando el Botón
Alimentación (
) en el Ventilador.
6. VELOCIDAD DEL VENTILADOR: Ahora puede ajustar la veloci-
dad del ventilador al nivel deseado - (3) Alta, (2) Mediana ó (1)
Baja - pulsando el Botón Velocidad (
) en el Ventilador.
7. FUNCIÓN DE TEMPORIZADOR: Este ventilador está equipado
con un temporizador. El temporizador puede ser programado
1 hora a 7 horas. Continúe oprimiendo el Botón Temporiza-
dor (
) para lograr el tiempo de programación deseado. Para
cancelar el temporizador, presione el botón del temporizador
hasta que se apague la luz.
8. Después de apagar el Ventilador, desconecte la unidad del
tomacorriente eléctrico.
Botón
Función
de
Temporizador
Botón
Velocidad
Botón
Alimentación
Figura 2
AAA
Baterías
Provided with an integral speed controller. Do not use with an external solid
state speed control device.
MODEL 5132
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic precautions should always be followed to reduce
the risk of fire, electrical shock and injury to persons, including the following:
Read all instructions before using this Fan.
PARA MONTAR EN LA PARED:
ESTE VENTILADOR se DEBE MONTAR EN UNA SUPERFICIE
PLANA ESTRUCTURALMENTE SOLIDA.
Montar conveniente que las anclas deben ser utilizadas para
montar el ventilador a la pared.
Al montar el Ventilador a la pared, el conjunto de cuerda debe ser
situado en el espacio entre el Cuerpo Trasero del Ventilador y la
Yunta del Ventilador. (Figure 3)
Yunta De
Ventilador
El Cuerpo
trasero de
Ventilador
Figura 3
Si usted pierde su mando a distancia, por favor Cliente de
llamada Serive para ordenar un reaplacement en 1-800-233-
0268, de lunes a viernes, entre las 8 a.m. y las 5 p.m. (Horario
Estándar del Este de los Estados Unidos).
This plug is a safety feature. It contains a safety device (fuse) that should not be removed. Discard product if the at-
tachment plug is damaged. To reduce the risk of fire, electric shock and personal injury, DO NOT remove, replace,
repair or tamper with the originally supplied plug. If the Fan does not function properly, it may be due to the safety
device incorporated in this plug. Call 800-233-0268, Monday - Friday, between 8:00 a.m. and 5:00 p.m. Eastern. If the
plug warning label is missing or damaged, call the toll free number for a replacement label.
POWER
TIMER
SPEED