Made in the U.S.A.
www.kettlerusa.com
info@kettlerusa.com
Copyright © Kettler USA 309.01
2577 18” Square Side Table
Contents:
(2) Legs
(1) Center Brace
(1) Table Top
(6) 1/4 - 20 x 2” Bolts
Tool Required:
#3 Phillips Head
Screwdriver
Assembly Instructions
1.
Place leg inside the frame underneath the
table top aligning the predrilled holes. Insert
two 1/4-20 x 2” bolts then tighten them with the
phillips screwdriver. Repeat on the other side.
2.
Place the center support brace vertically
between the legs aligning the predrilled holes.
Insert a 1/4-20 x 2” bolt thru the hole into the
center brace then tighten it with the phillips
screwdriver. Repeat on the other leg.
2.
1.
Aligning the predrilled holes on the leg with and
metal insert on the frame insert the bolt.