Filter
Top Products
English
10
The wall-hanging bracket weighs approximately 19.85 lds. and the Wide Plasma Display unit weighs
approximately 99.2 lbs.
While referring to the wall-hanging bracket installation dimensions in the diagram below, check the strength of
the wall in six installation locations, and add reinforcing if any of these locations are not strong enough.
Installation procedure
• The wall-hanging bracket has installation holes provided in 14 locations.
If the wall material will not allow sufficient strength to be obtained from using six installation holes, use some of the spare holes.
However, depending on the construction material used at the place of installation, cracks may develop if the screws are
inserted too close to each other.
Note
Note
• Use commercially-available M6 bolts which suit the wall materials for installation to the wall.
Note
Note
Installation procedure
First screw a bolt into the centre-
top hole.
Use a level gauge to correct the
alignment of the wall-hanging
bracket, and then screw bolts into
the remaining five holes.
1. Check the strength of the installation location.
2. Install the wall-hanging bracket to the wall.
• Install the wall-hanging bracket so that the arrow shown on the bracket is pointing upwards.
• If it is necessary to embed bolts or nuts beforehand because the wall is made from concrete, use the bracket
itself to determine the correct installation hole positions, or use the dimension diagram to calculate the hole
positions. Then embed the M6 bolts or nuts into the holes. Furthermore, when embedding the bolts, allow the
bolts to protrude from the wall by
13
/32 inches to
19
/32 inches.
36
5
/8
19
19
/64
17
23
/32
1
31
/32
1
1
/4
51
/64
51
/64
17
23
/32
17
23
/32
3
15
/16
19
/32
19
/32
Wall installation holes (6 locations)
Used for routing wires behind a wall
1
31
/32
Units : inches