JVC CA-HXZ7V Indoor Furnishings User Manual


 
– 34 –
English
Maintenance
To get the best performance of the unit, keep your discs, tapes, and mechanism clean.
Handling cassette tapes
If the tape is loose in its cassette, take
up the slack by inserting a pencil in one
of the reels and rotating.
If the tape is loose, it may get stretched,
cut, or caught in the cassette.
Be careful not to touch the tape surface.
Avoid the following places to store the
tape:
In dusty places
In direct sunlight or heat
In moist areas
Near a magnet
Cleaning the unit
Stains on the unit
Should be wiped off with a soft cloth. If the unit is heavily
stained, wipe it with a cloth soaked in water diluted neutral
detergent and wrung well, then wipe clean with a dry cloth.
Since the unit may deteriorate in quality, become
damaged or get its paint peeled off, be careful about the
following.
DO NOT wipe it with a hard cloth.
DO NOT wipe it strong.
DO NOT wipe it with thinner or benzine.
DO NOT apply any volatile substance such as
insecticides to it.
DO NOT allow any rubber or plastic to remain in
contact with it for a long time.
General Notes
In general, you will have the best performance by keeping
your discs and the mechanism clean.
Store discs in their cases, and keep them in cabinets or on
shelves.
Keep the unit’s disc trays closed when not in use.
Handling discs
Remove the disc from its case by
holding it at the edge while pressing
the center hole lightly.
Do not touch the shiny surface of the
disc, or bend the disc.
Put the disc back in its case after use
to prevent warping.
Be careful not to scratch the surface
of the disc when placing it back in its
case.
Avoid exposure to direct sunlight,
temperature extremes, and moisture.
To clean the disc
Wipe the disc with a soft cloth in a
straight line from center to edge.
Continued use of irregular shape discs
(heart-shape, octagonal, etc.) can
damage the unit.
DO NOT use any solvent—such as conventional
record cleaner, spray, thinner, or benzine—to clean
the disc.
EN34-36.CA-HXZ7/9V[US,UN,UX]/1 22/1/03, 4:53 PM34