Filter
Top Products
14 TOLL FREE: 1-888-668-9600
d
b
a
c
2
carpets
Maintenance
Changing the Headlight Bulb
You will need to order replacement
bulbs from: www.infinityvac.com
or contact Customer Service at:
1-888-668-9600.
Turn power off.
Unplug the vacuum.
Unlock vacuum and lay flat.
Insert a Flathead screwdriver into one of
the two top slots of the Headlight Cover;
gently pry off cover from slots.
Pull out the used light bulb.
Push new light bulb into place.
Slide bottom tabs of the cover in first;
then snap top slots into place.
Resetting the Motor Thermostat
Your Infinity Upright Vacuum is equipped
with a protective Motor Thermostat. If
the motor should overheat, the
thermostat shuts off the power.
To reset the Motor Thermostat:
Press the On/Off Button once to turn
power off.
Unplug the vacuum.
Check for clogged hose or filter; unclog
hose and replace filter. Refer to
Checking for Blockages on page13.
Wait 45 minutes for vacuum to cool;
then plug in the vacuum.
Press the On/Off Button to start the
vacuum.
Note: if vacuum still does not start,
contact Customer Service at:
1-888-668-9600
.
Replacing the Power Nozzle
Motor Belt
If the brush roll does not engage when
the carpet-to-floor pedal is in the
carpets position, the belt may be worn
or broken.
To remove worn or damaged Belt:
IMPORTANT: Depress carpets side
of pedal [back] to engage the brush
roll for proper belt alignment.
If pedal is in the bare floors/tools
position the belt will not align
properly on the belt shifter and will
break.
Turn power off.
Unplug the vacuum.
Remove Dust Cup Assembly.
Lock vacuum, lay flat and turn over.
Use Flathead screw driver [or a coin] to
turn three screws on the belt and brush
roll cover counter clockwise (a) to
unlock.
Remove Belt and Brush Roll Cover (b).
Grasp both sides of the Brush Roll; with
even tension, partially remove the right
side from the side holder first then the
left (c).
Then lift up the Brush Roll to relieve
tension on the belt.
Slip Belt off the Brush Roll.
Remove Belt from the motor-driven
shaft (d).
With the Brush Roll free, inspect for any
hair build-up or string; if present, carefully
cut out with scissors; take care not to
damage the bristles.