Hunter Fan 31018 Humidifier User Manual


  Open as PDF
of 2
 
Failure to ensure the tank is seated correctly could cause
the unit to leak water from the tank.
6. Insert the power adapter into the
bottom right side of the unit, then plug
the adapter into a wall outlet.
Personal UltrasonicPersonal UltrasonicPersonal Ultrasonic
Humidier
Model
31017
31018
31019
31020
READ AND SAVE THESE INSTRUCTIONS!
•  ALWAYS place the humidier in an area that is out of the
reach of children.
•  Before using the humidier, extend the cord and inspect
for any signs of damage. DO NOT use the product if the
cord has been damaged.
•  ALWAYS UNPLUG AND EMPTY the humidier when it is
not in operation or while it is being cleaned.
•  Do not use water bottles greater than 22 oz.
•  This product is intended for residential use only. DO
NOT use outdoors.
•  This device complies with part 18 of the FCC Rules.
Form# 44125-01 20120628 ©2012 Hunter Fan Co.
Transducer
Power Shut-off Float
Fan Exhaust
Bottle Cap
Power Adapter
Humidity Adjustment Knob
Mist Exhaust
Power Plug
Reservoir
Cover
Initial Setup:
1. Unravel and straighten the cord before use.
2. Set the unit on a at, waterproof surface.
3. Drop one demineralization tablet into your water bottle.
(note: The tablet will remove minerals from the water to
prevent dust accumulation. The benets of each tablet
will last up to one week between humidier cleanings.)
4. Use the water cap that came with your
humidier and press it down over the
mouth of your water bottle rmly.
5. Turn your water bottle upside down
and insert into the water reservoir.
Operation:
To turn the humidier on, turn the humidity
adjustment knob clockwise until you feel the
knob click. At this time the unit should be
on and you can adjust the amount of mist
the unit outputs by continuing to turn the knob clockwise. To
turn the unit off, turn the humidity adjustment knob counter-
clockwise until it clicks.
Maintenance:
1. Turn off the humidier and unplug the power adapter
from the wall and the unit.
2. Remove the water bottle from the unit and remove
the cap.
3. Empty the water from the bottle.
4. Rinse the humidier cap thoroughly with warm water.
Replace the water bottle if necessary.
5. Remove the reservoir cover from the humidier and
empty any remaining water.
6. Wipe any mineral deposits from the cover and base
with a soft cloth.
7. Replace the cover onto the base. Align
the notch on the cover with the groove
on the base. The mist exhaust should
be 45
°
to the right of the humidity
adjustment knob.