Filter
Top Products
Press cord into cord clip on back of
handle. Pull cord tight.
4
The assembled cleaner will look like this
drawing.
Assembling
Deep Cleaner
2
Attach upper handle
Remove clean solution tank (upper
tank) from deep cleaner.
2
With cord hook (A) to back of deep
c l e a n e r, push upper handle down onto
lower handle. Push b o l t s into holes on
f r ont of handle. If bolts will not go
t h r ough hole easily handle is not pushed
c o m p l e t e l y dow n .
3
3
4
6
7
Attach hose holder
Position hose holder (B) onto handle by
matching tabs on rack with openings on
back of handle. Make sure holes for
bolts are aligned.
4
8
5
9
8
Place nuts in recessed areas on
back of handle. Hold each nut in
place while tightening each bolt securely
(from the front of the handle) with a
Phillips screwdriver.
Only two nuts are needed on this model.
The extra nut is not required but has
been provided for your convenience.
5
A
C
B
When handle sections are com-
pletely together, squeeze trigger (C)
on upper handle to snap trigger rod In
place.
6
Replace clean solution tank (upper
tank) by positioning bottom first.
Press on tank handle to snap top of tank
into place.
7
Attach tool holder
Remove tool and taped screw from
holder.
Insert projections on rack into slots on
back of cleaner.
9