Filter
Top Products
© 2007 HeathCo LLC 598-1000-06
SL-6155 and SL-6250 Series
Decorative Wireless Doorbell
This package includes (Style of push button and chime may vary from illustra-
tion):
• Wireless chime
• Wireless push button w/battery
• Hardware pack
You'll need to buy 3 "D" alkaline batteries for the chime. In typical use,
alkaline batteries will last up to three years.
2. Install 3 alkaline "D" batteries.
Make sure batteries are oriented
properly.
1. Install alkaline type A23 12 volt push button
battery. Remove back of case by pushing in tab on
bottom with a small screwdriver. Make sure battery
is oriented properly (see page 3).
3. Test range. Temporarily position chime and push button where you want
them mounted. Press push button to verify chime and push button work
properly. If chime does not sound, see Troubleshooting.
4. Mount push button and chime.
Use either screws or double sided tape to mount
push button.
To mount with screws, remove back of case by pushing
tab on bottom with a small screwdriver.
Attach back of case to door jamb or wall. Snap front
of button on.
When attaching push button using double sided tape,
make sure the surface of the door jamb or wall is
clean.
See page 2 for help removing the
chime case.