Filter
Top Products
TYPE
‘D’
LR20
TYPE
‘D’
LR20
TR
-0035-RX
© 2007 DESA Specialty Products™ 598-1172-02
This package includes (Style of push button and chime may vary from illustration):
• Wireless chime cover • Wireless chime base
• Wireless push button w/battery • Hardware pack
You'll need to buy 3 “D” alkaline batteries for the chime. In typical use, alkaline batteries
will last up to three years.
Wireless Chime
Battery Cover
1. Install alkaline type A23 12 volt push button battery.
Remove back of case by pushing in tab on bottom with a
small screwdriver. Make sure battery is oriented properly
(see page 3).
2. Remove Chime Cover (see page 4).
3. Install 3 alkaline “D” batteries.
Press down on imprinted
arrows and slide battery cover to remove. Make sure bat-
teries are oriented properly.
Mounting Holes
TYPE ‘D’
LR20
TYPE ‘D’
LR20
TYPE ‘D’
LR20
1 2 3 4 5 6 7 8
VOLUME
4. Test range. Temporarily position chime and push button
where you want them mounted. Press push button to verify
chime and push button work properly. If chime does not
sound, see Troubleshooting.
5. Mount push button.
Use either screws or double sided
tape to mount push button.
• To mount with screws, remove back of case by pushing
in tab on bottom with a small screwdriver. Attach back of
case to door jamb or wall. Snap front of push button on.
• When attaching push button using double sided tape,
make sure the surface of the door jamb or wall is clean.