Filter
Top Products
COPYRIGHT © FEBRUARY, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#JK7970 PRINTED IN CHINA
Introduction
These dual mini halogen lamps provide wide area
illumination in indoor and outdoor environments.
Inventory (Figure 2)
1. Safety Screens (shown installed) ............... 2
2. Halogen Lamps .......................................... 2
3. Tripod ......................................................... 1
4. Mounting Arm ............................................. 1
Minor Components and Hardware
• Carriage Bolts M6-1 x 30 ...........................
2
• Threaded Knobs M6-1 ............................... 2
• Phillips Head Screws M4-.7 x 7 ................. 2
• Quartz Halogen Bulbs 500W ...................... 2
Note: Some components may already be pre-
assembled.
Assembly For Each Lamp
1. Unscrew the Phillips head screw holding the
lamp cover closed and open the lamp cover.
2. Install the safety screen by fitting the four
safety screen lugs between the glass and the
screen housing (
Figure 3), and secure the
screen tab to the housing using an M4-.7 x 7
Phillips head screw.
3. Using a clean, dry cloth, gently install a 500W
halogen bulb into the lamp socket. Close the
housing and tighten the Phillips head screw.
Note: NEVER touch a halogen bulb with
bare skin! Oils in human skin can cause
"hot spots" on the bulb, leading to drastically
shortened bulb life.
4. Mount the lamp to the mounting arm using
a threaded knob and an M6-1 x 30 carriage
bolt.
5. Seat the mounting arm in the tripod bracket
and snap the spring lugs into place.
If you need help with your new halogen lamps,
call our Tech Support at: (570) 546-9663.
Figure 3. Fitting locations of safety screen lugs.
Figure 2. Model H7861 Inventory
2
3
4
Figure 1. Model H7861.
MODEL H7861
DUAL MINI HALOGEN
LAMPS W/STAND 500W
INSTRUCTION SHEET
Screen
Tab
Screen
Lugs
2
1
1