Filter
Top Products
Introduction
The Model H6151-54 provides a strong air and
water tight seal using polyethylene or polypropyl
-
ene plastic bags.
Specifications
MODEL H6151-54
HEAT SEALING
MACHINES
INSTRUCTION SHEET
Figure 1. Model H6151 inventory.
COPYRIGHT © APRIL 2007 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#BL9116 PRINTED IN CHINA
A
B
C
Figure 2. Model H6152 identification.
Dial
Indicator
Light
Arm
Teflon
Strip
Inventory (Figure 1) Qty
A. Heat Sealing Machine ............................... 1
B. Teflon Fabric Strips .................................... 2
C. Heating Elements ....................................... 2
Model H6151 H6152 H6153 H6154
Power
200W 300W 400W 1000W
Seal Length
100mm 200mm 300mm 400mm
Seal Width
2mm 2mm 3mm 3mm
Seal
Thickness
0.2mm 0.3mm 0.4mm 0.4mm
Heating
Time
0.2-1.5
(sec)
0.2-1.5
(sec)
0.2-1.5
(sec)
0.2-2
(sec)
Dimensions
24 x 9
x 16cm
8 x 32
x 15cm
8.2 x 45
x 18cm
9.2 x 56
x 18cm
Weight
1.8kg 2.7kg 4.5kg 5.5kg
Operation
1. Remove the shipping brace, place the sealer
on a level surface and connect it to a 110V
AC power source.
2. Adjust the dial on the sealer (see Figure 2)
according to the thickness and type of plastic
bag.
Use a higher indicator setting for thick mate
-
rial and a lower setting for thin material.
3. Open the arm, place the shortest width of the
bag across the teflon strip and press the arm
down. The red indicator light will illuminate.
Note: The sealer will not turn ON until you
press the arm down. Therefore, you can leave
it plugged into power
between uses.
4. After the red light turns off, wait a second
for the seal to cool, then raise the arm and
remove the bag.