Filter
Top Products
Run Mode
54 332305B
With machine count set, the Rest Cycle (Pump OFF) is
ended when the machine count reaches zero (0000).
Machine Count
• A set number of triggered counts.
• The LED next to 1-2-3 illuminates (F
IG. 34).
• The display indicates the number of machine
counts remaining.
The example shown in F
IG. 34 shows the
remaining number of machine counts is 0045.
Backup Time
In Machine Count mode, if a Backup Time (maximum
rest time) has been set:
• The LED next to 1-2-3 illuminates (F
IG. 35).
• The display shows the amount of time remain-
ing till a fault.
The example shown in F
IG. 35 shows 4 hours
and 17 minutes remaining until a fault occurs.
• If the Machine Count requirements are met the
unit will exit the Rest Mode (Pump OFF) and
enter the Lubrication Mode (Pump ON).
OFF Time
In Max models if the Machine Count is set to 0000 then
Reset Mode (Pump OFF) is controlled with OFF Time
(see Time Control, page 51).
F
IG. 34
ON
OFF
!
1 23
HH MM
SS ##
MM : SS HH : MM
2
3
1
P
C
C
P
C
P
C
P
FIG. 35
ON
OFF
!
1 23
HH MM
SS ##
MM : SS HH : MM
2
3
1
P
C
C
P
C
P
C
P