Open as PDF
Faucet Mount Filtration System –
GXFM07HWW and GXFM07HBL
• Check with your state and local public works
department for plumbing and sanitation codes.
You must follow these guidelines as you install
the Water Filtration System.
• Be sure the water supply conforms with the
Performance Data. If the water supply conditions are
unknown, contact your municipal water company.
• Commonwealth of Massachusetts Plumbing Code
248 CMR shall be adhered to. The use of saddle
valves is not permitted; please consult your local
Do not use with water that is
microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system.
• Faucet Mount Filtration System—
GXFM07HWW or GXFM07HBL
• Faucet adapters and gasket
Optional accessories are available (Visa, MasterCard or
Discover cards accepted) by visiting our Website at
GEAppliances.com or from Parts and Accessories,
call 800.626.2002 (U.S.) or 800.663.6060 (Canada).
49-50227-4 07-09 JR
This Water Filtration System must be properly
installed and located in accordance with the
Installation Instructions before it is used.
• Check with your local public works department
for plumbing codes. You must follow their guides
as you install the Water Filtration System.
• Use the Water Filtration System on a potable,
safe-to-drink, home COLD water supply only.
The filter cartridge will not purify water or make
unsafe water safe to drink.
• DO NOT use on HOT water (100°F max).
• Install or store where it will not be exposed to
temperatures below freezing or exposed to any
type of weather. Water freezing in the system
will damage it.
• Your Water Filtration System will withstand up
to 125 psi water pressure. If your house water
supply pressure is higher than 100 psi during the
day (it may reach higher levels at night), install
a pressure reducing valve before the system is
WARNING — Do not use with water that
is microbiologically unsafe or of unknown quality
without adequate disinfection before or after the
system. Systems certified for cyst reduction may
be used on disinfected water that may contain
WARNING — Discard all unused parts
and packaging material after installation. Small parts
remaining after installation could be a choke hazard.
• Do not install filter in an outside location.
These systems are Tested and Certified by WQA against
NSF/ANSI Standard 42 for the reduction of Particulate
Class 1, Chlorine Taste and Odor and NSF/ANSI
Standard 53. See performance data sheet for details.
General Electric Company,
Appliance Park, Louisville, KY 40225