Filter
Top Products
GE SmartWater
Ô
Water Filtration System
INSTALLATION INSTRUCTIONS
Models GNUT05Z, GXUT05Z, GNUV10Z, GXUV10Z, GNUL30Z,
GXUL30Z & GXEM01Z
TABLE OF CONTENTS: Page #
Important Installation Recommendations 1
Tools and Materials Required for Installation 2
Step-by-Step Installation Instructions
— Feed water supply 3
— Electronic faucet installation 4
— Wall mounting 5
— Tubing connection 5
— Battery installation 5
— Filter cartridge installation 5
Parts List 6, 7
IMPORTANT INSTALLATION RECOMMENDATIONS
Read entire manual. Failure to follow all guides and rules could cause personal injury or property damage.
• Check with your local public works department for plumbing codes. You must follow their guides as you install the Water Filtration
system.
• Use the Water Filtration system on a potable, safe-to-drink, home COLD water supply only. The filter cartridges will not purify water
or make unsafe water safe to drink. DO NOT use on HOT water (100°F. max).
• Protect the Water Filtration system and piping from freezing. Water freezing in the system will break it.
• Your Water Filtration system will withstand up to 125 psi water pressure. If your house water supply pressure is higher than 100 psi
during the day (it may reach higher levels at night), install a pressure reducing valve before the system.
WARNING: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before
or after the system. GNUL30Z and GXUL30Z are certified for cyst reduction and may be used on disinfected water that may
contain filterable cysts. The water should be tested periodically to verify that the system is performing satisfactorily.
Small parts remaining after the installation could be a choke hazard. Discard safely.
7178977 (10-97) 215C1001P003-2 For Use and Care questions call: GE Answer Center® 800.626.2000
Pub. No. 49-5809-2 GENERAL ELECTRIC COMPANY, Appliance Park, Louisville, KY 40225
GNUT05Z, GXUT05Z, GNUV10Z,
GXUV10Z, GNUL30Z, and GXUL30Z are
tested and certified to ANSI/NSF Standard
42 for particulate reduction Class I,
chlorine reduction Class I and taste and
odor reduction.
GNUV10Z and GXUV10Z are tested and
certified to ANSI/NSF Standard 53 for
volatile organic chemical reduction.
GNUL30Z and GXUL30Z are tested and
certified to ANSI/NSF Standard 53 for cyst,
turbidity and lead reduction.
NSF
®
1