Filter
Top Products
11
3.5 Remove the assembly and drill the two holes using a No. 12
masonry bit. Push the rawl plugs into the holes, and place
the engine assembly in position, secure to the floor using
the screws provided. See diagram 2.
3.4 Having run the gas supply to the stove, PURGE THE
SUPPLY PIPE, this is essential to expel any debris that may
block the gas controls. connect the gas supply to the 8mm-
compression elbow at the RH rear corner of the stove,
ensuring that the pipe position does not interfere with the
location of the outer steel casing. See diagram 3.
3.7 Open the second carton and carefully remove the steel
outer casing components. Remove the protective plastic
coating from the two side assemblies and lower them onto
the engine assembly until the lugs locate as shown, check
that the feet are touching the hearth. See diagram 4.
3.8 Secure the upper front panel using the 4 nuts and bolts
provided. See diagram 5.
3.9 Locate the lower panels onto the lugs as shown. See
diagram 6.
INSTALLATION INSTRUCTIONS
INSTALLATION
2
AR0631
158mm
3
AR0879
AR0878
5
6
4