Filter
Top Products
8
Air Conditioner Features
(continued)
SLEEP FEATURE:
YOU WILL SEE:
FAULT CODES:
If the display reads"AS", a sensor
has failed.Contact your Authorized
Frigidaire Service Center.
If the display reads"ES", a sensor
has failed.Contact your Authorized
Frigidaire Service Center.
If the display reads"HS", a sensor
has failed.Contact your Authorized
Frigidaire Service Center.
Note: When unit is shut off in the Heat Mode, the fan will continue to run for a few seconds to dissipate residual
heat within the unit.
Note: In this “MODE” the set temperature will increase by 2 degrees F 30 minutes after the mode is selected. The temperature will then
increase by another 2 degrees F after an additional 30 minutes. This new temperature will be maintained for 7 hours before it returns to the or-
iginally selected temperature. This ends the “Sleep” MODE and the unit will continue to operate as originally programmed. The “Sleep”
MODE program can be cancelled at any time during operation by again pressing the “Sleep” button.
DO THIS:
PRESS SLEEP
BUTTON
LIGHT ON
TO TURN UNIT OFF:
YOU WILL SEE:
DO THIS:
PRESS ON/OFF
BUTTON
LIGHT ON:
YOU WILL SEE:
Note: This feature can be used with any combination of FAN Speeds, Timer, or Sleep Modes. When in the “Heat” Mode, the
fan will run continuously while heat is needed. The temperature will automatically be maintained anywhere between 55°F
(13°C) and 80°F (27°C). When the room set temperature is satisfied, the fan will cycle off and on to circulate and sample
the room air.
HEATING FEATURE(on some modes):
DO THIS:
PRESS
MODE BUTTON
SELECT HEAT