Filter
Top Products
7
Air Conditioner Features
(continued)
LIGHT ON
DO THIS:
PRESS
MODE BUTTON
CHOOSE
ENERGY SAVER
TIMER: DELAY STOP / START
FEATURE:
YOU WILL SEE HOW MUCH
FIRST
DO THIS:
PRESS
TIMER BUTTON
THEN
DO THIS:
PRESS
TEMP/TIMER
SET BUTTON
Then to adjust timer setting, tap or hold the UP arrow ( ) or the DOWN arrow ( ) to change delay timer at .5 hour increments, up to 10
hours, then by 1 hour increments up to 24 hours. The control will count down the time remaining until start (8, 7.5, 7, etc.). The Delay Start
mode automatically selects cooling with maximum Fan Speed. The temperature maintained will be the same as previously set. To change the
set temperature, press “COOL” then Up or Down arrows until the desired temperature is indicated on the display. After 5 seconds, the con-
trol will automatically change the display back to the hours remaining until the unit will start/stop. PRESSING the unit On/Off button at any
time will cancel the Delay Start/Stop function. The Delay Start/Stop Feature will work until the unit either starts or stops. Once that happens
he above steps have to be repeated again.
CHECK FILTER FEATURE:
YOU WILL SEE:
LIGHT ON:
Note: This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient operation and cooling. The LED (light) will
illuminate after 250 hours of operation. To reset after cleaning the filter, press the “Check Filter” button and the light will go off.
YOU WILL SEE:
Note: In this mode, the fan will continue to run for another 3 minutes after the compressor shuts off. The fan then cycles on for 2 minutes
at
10 minute intervals until the room temperature is above the set temperature, at which time the the cooling system turns back on.
TIME IS CHOSEN:
Note 1: For Delay Stop, the unit must be in the On position.
Note 2: For Delay Start, the unit must be in the Off position.
First, PRESS TIME BUTTON
LIGHT ON
TO USE THE
ENERGY SAVER FEATURE: