Friedrich SC Window User Manual


  Open as PDF
of 4
 
RACINST4 (7/97) Page 1
ATTACH GASKETS TO BACKSIDE
OF THE BRACKETS AT THE TOP AND SIDES.
SIDE BRACKET
W+1"
ACORN NUT
SIDE BRACKET
SILL CHANNEL
FIGURE 1
INSTALLATION INSTRUCTIONS
FOR "SC" MODELS
CASEMENT SASH WINDOW INSTALLATIONS.
These models will fit casement window openings as follows:
HEIGHT: 10-13/16" Minimum to 11-3/4" Maximum
WIDTH: 14-3/4" Minimum to 18-3/8" Maximum
STEP 1 Remove the unit from the shipping carton. Remove the tape holding the decorative front in place.
Remove the front and place it out of the way. Slide the unit out of the shell. As you slide the unit out,
you will notice a foam gasket between the chassis and the cabinet. Save the gasket for STEP 7.
STEP 2 Remove the glass, putty and window crank, if necessary. Measure the horizontal width dimension “W”
or window frame opening (Figure 1). If dimension “W” is 16" (405 mm) or less, no adjustment of the
side bracket is necessary. If the dimension is more than 16" (405 mm) – loosen the two (2) acorn nuts
and slide the side brackets out. (Add one inch (25 mm) to the measured “W” dimension for this
adjustment.) Tighten the acorn nuts. (Figure 2).
FIGURE 2
next